LIVEX 49803-91 Meadow 3 Light Pendant Instruction Manual
- October 30, 2023
- LIVEX
Table of Contents
LIVEX 49803-91 Meadow 3 Light Pendant Instruction Manual
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Be care not to lose any small parts necessary for installation.
-
Raise the shade(E) onto the thread pipe of lamp holder(D), lock it securely with the column nut(C), then lock the cord securely with the plastic screw. While holding the lamp body towards the ceiling, attach the single bar to the Junction Box with the two junction box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
-
By measuring, determine correct cord length needed for proper hanging height. NOTE: slide wire clip to the proper position, then you may properly cut the cord is a too long part.
-
Connect the electrical cord as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet box has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
-
Install the canopy(A) onto the junction box, the pipe thread protrude from the hole in the canopy and lock it securely with the column nut(B), then lock the cord securely with the plastic screw.
NOTE : THE SHADE OF THE PRODUCT MAY VARY. -
Install the light bulbs(not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
Your installation is now complete. Return power to the junction box and test
the fixtur
hank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at:
800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>