LIVEX 41256, 48826 Lighting Uptown 8 Light Antique User Guide
- June 4, 2024
- LIVEX
Table of Contents
User Guide
41256, 48826 Lighting Uptown 8 Light Antique
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
41256 48826
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixtures and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
- Raise the end of the pipe thread into the coupling, and lock it with the hex nut until tight. Raise the other end of the pipe thread into a single bar (D), place the lock washer over the end of the thread protruding through the single bar, and lock it securely with the hex nut.
- Slide the electrical wires through the tube(K)/(J)/(I)/(G)/ring(H)/canopy(F) and assembled single bar(D). By measuring, determine the correct tube length needed for proper hanging height.
- Raise the tube(K) to the center pipe thread of the lamp body(L), raise the tube(J)/(I)/(G), and assembled single bar(D) to the screw pipe nipple in order, then by turning it clockwise until tight.
- While holding the assembled single bar(D) of the fixture body to the ceiling junction box with junction box screws (E) as shown, tighten screws securely with a screwdriver. The side of the single bar marked “GND” must face out. The junction box is not included.
- Connect the electrical wires as Shown in Fig.2 , making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise, connect the fixture’s ground wire directly to the single bar with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Slide the canopy(F) onto the Junction box, and lock it securely with the ring(H) until tight.
- Install the light bulbs(Not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
- Raise the end screw of the crystal stick(A) and insert it into the top screw hole of the lamp body(L), by turning it clockwise until tight. Raise the end screw of the crystal stick(B) and insert it to the bottom adjacent screw hole of the crystal stick(A), by turning it clockwise until tight. Assembled using the same method the other crystal sticks(order: A, B, A, B, A……). Note the crystal stick(C) is only one, you must mount it to the bottom center screw of the lamp body(L).
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at
800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED. LIVEX L I G H T I N G, I N C.
D O C 20211241256
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>