LIVEX 1331 Wall Light Instruction Manual
- June 16, 2024
- LIVEX
Table of Contents
LIVEX 1331 Wall Light
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
- WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
- Thread the two mounting screws into the pre-drilled holes in the mounting plate, spaced about the same distance apart as the holes in the fixture back plate. Attach the mounting plate to the junction box using two junction box screws as shown. The side of the mounting plate marked “GND” must face out. The junction box is not included.
- Guide fixture wires through the hole in the centre of the mounting plate.
- Follow wiring instructions carefully (see fig.2).
- Place the lamp body(D) onto the mounting plate, aligning the holes with mounting screws, then lock it securely with the ball nut(E).
- Raise the glass shade (C) and cover (B) to the socket holder, and lock it securely with ring (A) until snug.
- Install the light bulbs (not included) according to the fixture’s specifications.
NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Product Information
Specifications
- Model Number: 1331, 1332, 1333, 1334, 1335
- Power Source: Electrical
- Maximum Wattage: Not specified (Refer to fixture’s specifications)
FAQ
Q: What should I do if I lose any small parts necessary for installation?
A: If you lose any small parts necessary for installation, please contact our
customer service at 800-761-8056 or
visit us online at www.livexlighting.com for
assistance with parts.
Q: What is the maximum wattage rating for the light bulbs?
A: The maximum wattage rating for the light bulbs is not specified. Please
refer to the fixture’s specifications for the recommended maximum wattage.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>