DYNOJET PC6-20022 Power Commander 6 Installation Guide

: June 4, 2024
: Dynojet

Table of Contents

PC6-20022 Power Commander 6
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS CRANK
WIRE CONNECTIONS
INSTALLING THE POWER COMMANDER 6
Read User Manual Online (PDF format)
Download This Manual (PDF format)

POWER COMMANDER 6
Installation Guide for PC6-20022
Model Coverage: 2010/2018 Suzuki RMX450Z

PC6-20022 Power Commander 6

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

INPUT ACCESSORY GUIDE

DYNOJET PC6 20022 Power Commander 6 - Figure 1

OPTIONAL ACCESSORY INPUTS CRANK

Map
(Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the ﬂ y between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important.
Shifter
(Input 1 or 2) Used for clutch-less full-throttle upshifts. Insert the wires from the Dynojet quick shifter into either Input 1 or Input 2. The polarity of the wires is not important. Set to Input 2 by default.
Speed
If your application has a speed sensor then you can tap into the signal side of the sensor and run a wire into this input. This will allow you to calculate gear position in the Control Center Software. Once gear position is set up you can alter your map based on gear position and setup gear-dependent kill times when using a quick shifter.
Analog
This input is for a 0-5v signal such as engine temp, boost, etc. Once this input is established you can alter your fuel curve based on this input in the Power Core software.
Launch
You can connect a wire to either Input 1 or Input 2 and then the other end to a switch. This switch when engaged (continuity) will only allow the RPM to be raised to a certain limit (set in the software). When released, you will have full RPM.

WIRE CONNECTIONS

To input wires into the PC6 ﬁrst remove the rubber plug on the backside of the unit and loosen the screw for the corresponding input. Using a 22-24 gauge wire, strip about 10mm from its end. Push the wire into the hole of the PC6 until it stops and then tightens the screw. Make sure to reinstall the rubber plug.
NOTE: If you tin the wires with solder it will make inserting them easier.

INSTALLING THE POWER COMMANDER 6

DYNOJET PC6 20022 Power Commander 6 - Figure 3

Remove the seat and fuel tank.
Secure the PC6 to the rear fender using the supplied
Dual Lock strips. Make sure to clean both surfaces with the alcohol swab before attaching.
Route the PC6 harness along the left side of the subframe. Use the stock cable ties to secure the PC6 harness to the stock wiring harness.
Attach the ground wire from the PC6 to the sub-frame bolt.
Route the PC6 harness along the left side of the sub-frame and go towards the throttle body. Use the stock cable ties to secure the PC6 harness to the stock wiring harness.
Unplug the stock wiring harness from the injector.
Unplug the stock Throttle Position Sensor connector. This is a GREY 3-pin connector.
Plug the PC6 wiring harness in line with the stock wiring harness and injector.
Plug the PC6 wiring harness in line with the stock TPSconnectors.
Reinstall the fuel tank and seat.