HYUNDAI FOB-4F87M54 FOB Smart Key User Manual
- June 16, 2024
- HYUNDAI
Table of Contents
HYUNDAI FOB-4F87M54 FOB Smart Key
Outline & Description
-
The Outline of FOB-4F87M54
– This unit is a Transmitter.
– FOB-4F87M54 is a part of Remote Keyless System.
– This unit controls door lock/door unlock/tail gate open/panic/remote engine start stop/forward/backward/PSD LH/PSD RH wirelessly. -
Description of FOB-4F87M54
-
Introduction
– This unit has 9 buttons.
– This unit uses a battery(CR2450) -
Electrical Characteristics
Model| Transmitter
---|---
Center freq.| 433.92MHz
Power| 1mW under
Modulation| FSK
Approval No.| FOB-4F87M54
Oper. Voltage| 3V DC
Oper. Temp.| -10 ~ +60 ℃ -
(3-1) Data Format : UHF 433.92MHz
– Data Frame
Transmission
Specification
-
Baud Rate : 7.8 kbps
-
Coding Method : Manchester
-
Total Data for 1 sending : 178bit/frame
-
Total Time for 1 sending :309ms (with off-time
- Antenna Type: PCB Pattern Antenna / Antenna Gain: – 11.61 dBi
FCC/ISED NOTICE
[FCC]
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could avoid your authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be collocated or operating in conjunction with any
other antenna or transmitter unless authorized to do so by the FCC
[ISED] This device contains licence‐exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence‐ exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.