HOMCOM 853-027V90 Handheld Clothes Steamer Instruction Manual
- June 16, 2024
- HOMCOM
Table of Contents
IN221200028V01_UK_FR_DE_IT
853-027V70_853-027V90 STEAM BRUSH
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
IMPORTANT SAFETY INSTRUCTIONS
When using your steam brush, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
- Use steam brush only for its intended use.
- To protect against a risk of electric shock, do not immerse the steam brush in water or other liquids.
- Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
- Do not allow cord to touch hot surfaces. Let steam brush cool completely before putting away. Loop cord loosely around steam brush when storing.
- Always disconnect steam brush from electrical outlet when filling with water or emptying and when not in use.
- Do not operate steam brush with a damaged cord or if the steam brush has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the steam brush. Take it to a qualified serviceman for examination and repair. Incorrect reassembly can cause a risk of electric shock when the steam brush is used.
- Close supervision is necessary for any appliance being used by or near children. Do not leave steam brush unattended while connected or on an ironing board.
- Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam brush upside down – there may be hot water in the reservoir.
- If the malfunction indicator goes on, the flatiron is not operating normally. Disconnect from the power supply and have the flatiron serviced by qualified service personnel.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Care when using the appliance due to the emission of steam.
- Unplugging the appliance during filling and cleaning.
SPECIAL INSTRUCTIONS
- To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
- If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
More specifically:
DO NOT let children or untrained persons use the appliance without
supervision.
NEVER immerse the steam brush, cable or plug in any liquid.
DO NOT leave the hot steam brush touching fabrics or very inflammable surfaces.
DO NOT leave the appliance unnecessarily plugged in.
Disconnect the plug from the mains when the appliance is not being used.
NEVER touch the appliance with wet or damp hands.
DO NOT use the power cord or the appliance in order to pull the plug out of
the socket.
DO NOT leave the appliance exposed to the weather (rain, sun, etc. ).
DO NOT leave the steam brush without supervision when it is connected to the
power supply.
DO NOT fill the reservoir with water before removing the plug from the socket.
PLEASE NOTE!
Do not use chemical additive, scented substances or decalcifies. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.
DESCRIPTION OF DEVICE
(1). Shell body
(2). Tank liner
(3). Steam Button
(4).Filler cap
(5). Handle
(6). Power Cord| (7). Water tank
(8). Front Shell
(9). Faceplate
(10). Steam brush
(11). Switch button
---|---
GENERAL INSTRUCTIONS
When using the steam brush for the first time, you may notice a slight emission
of smoke and hear some sounds made by the expanding plastics. This is quite
normal and it stops after a short time. We also recommend passing the iron
over an ordinary cloth before using it for the first time.
Please note:
Distilled or purified water is recommended to use for ironing. STEAM
IRONING
Filling Water tank
– Check that the plug is disconnected from the socket.
– Put the water tank（07） out of the main body [Fig. 1].
– Open the Filler cap (04).
– Fill distilled or purified Water by cup, be careful not to exceed Max
position (about 140 ml) [Fig. 2].
– Close the Filler cap.
– Put the water tank on the main body
Start Ironing
– Plug in POWER. [Fig. 3] – Put the plug in the socket. Push the Switch
button（11）
– The steam brush starts to heat, and the indicator light start flashing in
blue around for 15 seconds.
– When the heating is completed, the indicator light stops flashing and keep in
blue.
– Press the steam button (03) to release the steam. If you need to continue to
release the steam, you can push the steam button (03) 3 seconds. [Fig. 4].
– The product has two level steam, if you need lower steam, press the switch
button (11) once, the indicator light becomes green.
Warning: In the heating process, the indicator is still flickering.
Pressing the steam button at this time can’t RELEASE steam.
Only after the heating is completed, the steam CAN be release.
This is Controlled by electronic.
THE USE OF STEAM BRUSH
– Brush fasten with the hook on the front of the appliance caught the tail off
[Fig. 5] – Fold up the steam brush. [Fig. 6] HOW TO PUT IT AWAY
– Unwatering by turning the water tank upside down and gently shaking it.
– Cool the steam brush completely.
– Roll up the power cord
ADVICE FOR GOOD IRON
To avoid marking silk, woolen or synthetic garments shiny, iron them inside
out.
To avoid marking velvet garments shiny, iron in one direction (following the
fiber).
The heavier the washing machine is loaded, the more garments come out
creased. Many fabrics are easier to iron if they are not completely dry.
For example, silk should always be ironed damp.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
If you have any questions, please contact our customer care center.
Our contact details are below:
0044-800-240-4004
enquiries@mhstar.co.uk
IMPORTER ADDRESS:
MH STAR UK LTD
Unit 27, Perivale Park,
Horsenden lane South
Perivale, UB6 7RH
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>