MUSICAL FIDELITY X-PSU Series Upgrade Power Supply Instruction Manual
- June 16, 2024
- MUSICAL FIDELITY
Table of Contents
X-PSU Series Upgrade Power Supply
Instruction Manual
X-PSU Series Upgrade Power Supply
Introduction
Thank you for purchasing the X-PSU X-Series Upgrade Power Supply. The X-PSU upgrades and powers up to four X-Series units. We hope that by further improving the performance of your XSeries components the X-PSU will bring you many years of listening pleasure.
Installation Precautions
Your new X-PSU is designed and built to provide trouble-free performance, as with all electronic devices it is however necessary to observe a few precautions. Please ensure that you have complied with these before you connect the power to your X-PSU. Retain this guide for future reference.
- Do not use the X-PSU near water.
- Keep the X-PSU away from heat sources such as radiators.
- Place all connecting cables where they are not likely to be walked on or trapped by items placed on them.
This Hi-Fi product has been tested to ensure that its operation will not be
adversely affected by normal background levels of R.F.I. (Radio Frequency
Interference). It is possible that if the unit is subjected to abnormally high
levels of R.F.I. the unit may not perform as expected. In the unlikely event
of this happening please contact Musical Fidelity’s service department.
Do not remove any covers, the X-PSU will not be covered under warranty if it
has been tampered with. There are no adjustments within. Please refer all
service work to an authorised Musical Fidelity agent.
Connections
All connections should be made before the mains lead is plugged in.
The X-PSU has four power outputs (labelled 1 to 4) suitable for use with the
X-Series range of Hi-Fi accessories.
To connect the X-PSU into your system firstly make sure that the X-PSU is
switched off by the on/off button situated on the front panel.
Plug the supplied mains lead into the IEC type mains inlet situated on the
X-PSU rear panel and then into your mains outlet socket.
Connect the outputs from the X-PSU to the power inputs of each of your
X-Series units (marked 12V 500mA) using the supplied X-Series power leads.
Switch on the X-PSU using the front panel button and the power LED on the
X-PSU and the power LEDs on each X-Series unit should light up indicating that
your system is now ready for use.
When switching your Hi-Fi on or off it is always advisable to follow the
following routine:-
Switching on : Switch on your X-Series components before switching on your
amplifier.
Switching off : Switch off your amplifier before switching off your X-Series
components.
SPECIFICATIONS
Outputs | Four @ 12V AC 20VA |
---|---|
Power requirement | 100/115/230V AC 50/60Hz |
Factory preset
Power consumption| 60W
Standard accessories| IEC mains lead Set of four X-Series power leads
Dimensions (mm)| 110 x 110 x 220 (W x H x D) Width and height include feet
Musical Fidelity reserves the right to make improvements which may result in
specification or feature changes without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>