iHome iKBT70 Karaoke Machine Instruction Manual
- June 16, 2024
- iHome
Table of Contents
iHome iKBT70 Karaoke Machine Instruction Manual
Controls and Indicators
SPEAKER TOP VIEW
Power
Press and hold to turn ON/OFF Short press to switch modes:
Bluetooth, AUX or TF mode.
Play/Pause
Short press to play/pause audio.
Short press to answer/end phone call.
Press and hold to reject incoming call.
Double press to redial previous call.
Volume Up
Press and hold to increase volume.
Short press to skip to next track.
Volume Down
Press and hold to decrease volume.
Short press to skip to previous track.
Light Modes
Short press to cycle through 11 dierent light modes. Press and hold to turn
light ON/OFF. Double press to check battery status.
SPEAKER BACK PANEL
AUX – Connect a 3.5mm audio cable (not included) to the AUX jack on the
back of the speaker, and the other end to your audio device to play audio
without using Bluetooth.
TF – Insert a TF card (not included) to play audio files.
DC5V Charging Port – Connect the included USB-C charging cable to charge
the speaker.
MICROPHONE CONTROLS
Power Button – press and hold to turn ON/OFF – short press to mute/unmute
mic
Volume Up – short press to increase mic volume
Volume Down – short press to decrease mic volume
Voice Modes – short press to cycle through 6 modes
LED Indicator – red = charging / blue = wirelessly connected
USB Charging Port
Charging the Speaker and Microphone
-
USB-C charging cable (included)
-
USB AC adaptor (not included)
NOTE: As per illustration, insert TF card completely in the speaker until
it clicks.
To remove, press in slightly to disengage and pull out.
To charge the battery, connect the larger plug of the included USB-C charging cable to the powered USB port of a computer or a USB/AC adapter, and then connect the smaller plug to the USB-C charging port on the side of the speaker, and the bottom of the microphone.
(Note: The speaker and microphone must be charged separately.)
The Charging Indicator will glow red while charging. The indicator will turn o when the unit is fully charged and ready to use.
Connecting to Bluetooth
The first time the speaker is powered on, it will enter auto-pairing mode, indicated by flashing blue LEDs.
- Make sure Bluetooth is enabled on your device (check in Settings).
- “iHome iKBT70” will appear on your device’s Bluetooth menu.
- Select “iHome iKBT70” to complete pairing.
Manual Pairing: Press and hold the Play/Pause Button for 2 seconds to enter pairing mode. Follow steps 1-3 above to complete pairing. To reset pairing table, press and hold the Play/Pause Button for 10 seconds.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions in their entirety before using or charging the device. Failure to do so may result in personal injury or property damage if used improperly. Keep these instructions handy for future reference. This device uses an internal non- replaceable, rechargeable lithium battery that should last the lifetime of the device. If you suspect that your battery maybe dead, try charging it for an extended period of time or try resetting the unit.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Heat – The speaker and microphone should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this product during lightning storms or when unused for long periods of time.
- Damage Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
- No naked flame sources, such as lighted candles, should be placed on this product.
- Attention should be drawn to the environmental aspects of battery disposal.
- This product is suitable for use in tropical and/or moderate climates.
- Do not dispose of batteries in the household trash or fire.
- If the unit is to be unused for an extended period of time, such as a month or longer, charge the unit fully before storage.
- Always use a UL/ETL certified charging adapter (not included), and the supplied USB charging cable.
WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:
- Never dispose of used batteries/electronics with ordinary solid wastes, since they may contain toxic substances.
- Always dispose of used batteries/electronics in accordance with the prevailing commuN nity regulations.
- Many electronics retailers now recycle batteries and other electronic components at no charge. Visit www.call2recycle.org for more information.
GENERAL BATTERY PRECAUTIONS
- Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
- Rechargeable batteries are only to be charged under adult supervision.
- Always charge Lithium batteries on surfaces that won’t catch on fire such as cement, steel, ceramic or stone. Wooden tables and carpeted floors are not recommended charging surfaces.
- Never leave a charging lithium device unattended.
- Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances.
- Avoid charging a rechargeable battery when the temperature is not within 5°C – 35°C (41° – 95° Fahrenheit).
- Never expose a battery to any liquid.
- Never expose a battery to excessive heat such as direct sunlight or fire. Never use or store a battery device in an unventilated vehicle where excessive internal temperatures may be encountered.
- Always keep batteries out of the reach of infants and small children.
- Do not charge batteries near flammable products or liquid.
- This product is NOT a toy.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
- Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
One Year Limited Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion, replace this product without charge. This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by Customer Service. If service is required, please contact Customer Service at ihome.com/support to obtain a Return Authorization Number and shipping instructions.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose
for which it was designed. It does not cover (i) products which have been
damaged by negligence or willful actions, misuse or accident, or which have
been modified or repaired by unauthorized persons; (ii) cracked or broken
cabinets, or units damaged by excessive heat; (iii) damage to digital
media players, CD’s or tape cassettes (if applicable); (iv) the cost of
shipping this product to the Factory Service Center and its return to the
owner.
This warranty is valid only in the United States of America and does not
extend to owners of the product other than to the original purchaser. In no
event will SDI or any of its aliates, contractors, resellers, their ocers,
directors, shareholders, members or agents be liable to you or any third party
for any consequential or incidental damages, any lost profits, actual,
exemplary or punitive damages. (Some states do not allow limitations on
implied warranties or exclusion of consequential damages, so these
restrictions may not apply to you.) This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Your acknowledgment and agreement to fully and completely abide by the above
mentioned disclaimer of warranty is contractually binding to you upon your
transfer of currency (money order, cashier’s check, or credit card) for
purchase of your SDI product.
© 2023 SDI Technologies, Inc.
All rights reserved.
iKBT70_QSG_030123-A Printed in China
iKBT70 – QSG – English
Size: 306 x 150 mm (folded 102 x 150 mm)
Material: 85gsm wood free paper
Color: 1C + 1C (black)
Mar. 01, 2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>