Xtracycle 2023 Cargo Electric Bikes BoomBox Installation Guide
- June 16, 2024
- Xtracycle
Table of Contents
Boombox installation 2023
INSTALLING THE BOOMBOX BAG
ON A LONGTAIL REAR RACK
2023 Cargo Electric Bikes BoomBox
Please note:
Each BoomBox bag is identical. There is no left side bag or right side bag.
-
Remove any bag system you have installed.
The 8 areas marked in RED are where the BoomBox will attach to when using the All-in-one-racks. For all other racks without a pannier rail installed you’ll attach the BoomBox at the 4 red squares on the sides and bottom and the blue square in the center. -
It’s easier to start with the 4 tabs on top, going one by one down the pannier rail. Open the velcro tabs and fold the top tab over the pannier rail.
-
Pull the velcro tab tight and press into the loop side of the velcro on the rear of the bag.
-
Fold up and secure the bottom tab of velcro and repeat with the other 3 tabs along the pannier rail.
-
Wrap the rear velcro loop around the All-in-One rack, thread through the plastic ring, and fold back on itself to secure. Repeat on the front velcro loop.
-
Wrap the rear underside velcro loop around the frame, thread through the plastic ring, and fold back on itself to secure. Repeat on the front underside velcro loop.
-
You have successfully installed your BoomBox!
Care & Maintenance
If the BoomBox Bag becomes dirty, it can be gently scrubbed with a washcloth and soap and water. Hand wash only and air dry.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>