Whirlpool WDF550SAA Undercounter Dishwasher Instruction Manual
- June 16, 2024
- Whirlpool
Table of Contents
Whirlpool WDF550SAA Undercounted Dishwasher Instruction Manual
PRODUCT MODEL NUMBERS
WDF550SAA WDF550SAF
Electrical Requirements: 120-volt, 60- z, AC-only, 15- or 20-amp fused electrical supply. Copper wire only. A time delay fuse or circuit breaker and separate circuit is recommended.
If direct wiring dishwasher: Use flexible, armored, or nonmetallic,
sheathed copper wire with grounding wire that meets the wiring requirements
for your home and local codes and ordinances.
Use a UL Listed or CSA Approved strain relief.
If connecting dishwasher with a power supply cord:
Use Power Supply Cord Kit (Part Number 4317824) marked for use with
dishwashers. Follow the kit instructions for installing the power supply cord.
Power supply cord must plug into a grounded 3 prong, outlet, located in the
cabinet next to the dishwasher opening. Outlet must meet all local codes and
ordinances.
Water Supply Requirements: A hot water line with 20 to 120 psi (138 to 862 kPa) water pressure. Water temperature must be 120°F (49°C) water at dishwasher. Use ³⁄₈” O.D. copper tubing with compression fitting or flexible braided water supply line (Part Number 4396897RP) (¹⁄₂” minimum plastic tubing is not recommended). Use a 90° elbow with ³⁄₄” hose connection with rubber washer. Do not solder within 6″ (15.2 cm) of the water inlet valve.
Drain Requirements:
-
Use the new drain hose supplied with your dishwasher.
NOTE: If a longer drain hose is required: -
Use a new drain hose with maximum length of 10 ft (3 m) that meets all current AHAM/IAPMO test standards.
-
Use a new drain hose that is resistant to heat and detergent.
-
Use a new drain hose that fits the 1″ (2.5 cm) drain connector on the dishwasher.
-
Connect drain hose to waste tee or disposal inlet above drain trap in house plumbing.
-
Connect drain hose to house plumbing 20″ (50.8 cm) minimum above the floor.
NOTE: It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter or be connected to an air gap. -
Use a drain air gap if the drain hose is connected to house plumbing lower than 18″ (45.7 cm) above the subfloor or floor.
Drain Air Gap
- Use ¹⁄₂” (1.3 cm) minimum I.D. drain line fittings.
NOTE: Do not connect drain lines from other devices to the dishwasher drain hose
PRODUCT DIMENSIONS
Side View
* To front of door frame
Rear View
CABINET CUTOUT DIMENSIONS
- Underside of countertop to floor
NOTES:
- Cut holes in shaded area of cabinet walls or floor for plumbing and electrical service.
- ADA installation – 32¹⁄₂” (82.5 cm) beneath 34″ (86.4 cm) high countertops may be accomplished by adjusting the to kick and leveling legs.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>