FLAGRANTI Otouch Masturbator Ninja User Manual
- June 16, 2024
- FLAGRANTI
Table of Contents
FLAGRANTI Otouch Masturbator Ninja
Specifications
- Waterproof: Yes
- Lubricant Compatibility: Water-based lubricants only
- Battery: Integrated Li-on battery
- Charging: USB cable included
Product Usage Instructions
Maintenance
After each use, rinse the masturbator with lukewarm water and soapy detergent. You can also use an erotic cleaner, which also helps to remove microscopic dirt. Simply spray the product, leave it on for about 1 minute and then dry with a towel or cloth that does not leak fibers.
Waterproof
The masturbator is water resistant, so maintenance is very easy. The masturbator can be splashed with water, but you MUST NOT immerse it in water! Waterproof means that you could completely submerge the product in water and enjoy water play. Due only to the water resistance of the product, this is not possible in this case.
Lubrication
Use only water-based lubricants. Other lubricating gels could damage the surface of the aid and it could become sticky.
Drive and Charging
The masturbator is powered by an integrated Li-on battery, which is
approximately half charged from the factory, but we recommend that you fully
charge it before first use. Charge the battery using the included USB cable,
which can be plugged into a phone adapter, PC or power bank. When charging,
the LED flashes and when fully charged, the LED control lights up permanently.
Storage
Store separately from other erotic aids in a dry and dark place.
Packaging Contents
- Masturbator
- USB cable for charging
CONTROL
- Hold down the top button with the M symbol for 3 seconds to turn it on. The masturbator will start the first vibration mode and the blue LED will light up.
- Further short presses of this button change the individual vibration and pulsation rhythms.
- Hold down the bottom button with the thermometer symbol to switch on the heating function to 35 °C,which is indicated by a flashing red LED.
- Pressing this button briefly will turn on the red LED and start heating to 45 °C.
- The heating and vibration functions can be triggered independently of each other.
- Both functions must then be switched off with their own button by long pressing and holding the respective button for 3 seconds.
Trinet Corp., s.r.o.
Provozní 5560/1b
72 00 Ostrava – Trebovice, Czech Republic
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>