SOLBELLO Beach Sun Shade User Manual

SOLBELLO Beach Sun Shade User Manual

SETUP

1. REMOVE YOUR SOLBELLO® UMBRELLA FROM IT’S CARRY BAG(7).
2. PLACE THE BOTTOM POLE WITH AUGER(4) INTO SAND. UNFOLD HANDLE(3) AND SCREW CLOCKWISE UNTIL POLE IS SECURE IN SAND. DEPTH SHOULD BE APPROXIMATELY 14”. REFERENCE RED LINE FOR SUGGESTED DEPTH.
   *NOTE: REQUIRED DEPTH MAY VARY FROM BEACH TO BEACH DEPENDING ON SAND CONSISTENCY.
3. UNROLL THE FABRIC(2) FROM THE UPPER POLE.
   *NOTE: WE RECOMMEND HOLDING THE END OF THE FABRIC AND GENTLY DROPPING THE UNIT IN THE SAND TO UNROLL.
4. STANDING WITH YOUR BACK TO THE WIND, UNFOLD THE UPPER PORTION AND SLIDE THE CENTER SLIDER(1) UP TO IT’S LOCKED POSITION WITH THE SAIL FLOWING AWAY FROM YOU.
   *NOTE: VELCRO CLOSURE AND TAG SHOULD BE ON UNDERSIDE OF SAIL.
5. PLACE THE TOP MAST INTO THE BOTTOM MAST.

PACK

1. LIFT UPPER POLE FROM BOTTOM POLE, SLIDE CENTER(1) DOWN TO FOLD ARMS.
2. WITH THE WIND AT YOUR BACK, ROLL THE SAIL(2) UP ONTO UPPER PORTION AND SLIDE INTO BAG.
3. REMOVE LOWER POLE FROM THE GROUND AND WIPE OFF SAND.
4. CAREFULLY SLIDE THE LOWER POLE INTO THE OPEN DIVISION OF THE BAG.
5. STORE IN A COOL DRY PLACE.

No-Wind-Kit

**USE AT YOUR OWN RISK!
THE NO-WIND-KIT IS TO BE USED WHEN THERE IS NO WIND, OR IF THE WIND IS LIGHT AND SWITCHING DIRECTIONS.

*SHADE SHOULD STILL FACE INTO DOMINANT WIND DIRECTION (IF ANY).

1. REMOVE THE TWO BUNGEES(5) AND THE TWO ANCHORS(6) FROM THE STORAGE COMPARTMENT OF THE CARRY CASE(7).
2. HOOK EACH BUNGEE ONTO THE BACK CORNERS OF THE SAIL(2).
3. AT A 45º ANGLE, EXTEND (DO NOT STRETCH) ONE BUNGEE AND PLANT THE CONNECTED ANCHOR INTO THE SAND.
   *ANCHOR SHOULD PLANT INTO SAND AT A 45º ANGLE LEANING AWAY FROM THE SHADE.
4. REPEAT STEP #3, ON SECOND CORNER.
5. IF THE WIND PICKS UP, REMOVE THE NO-WIND-KIT IMMEDIATELY.

PARTS

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>