Whirlpool WZF34X16D Freezer User Guide
- June 16, 2024
- Whirlpool
Table of Contents
Whirlpool WZF34X16D Freezer
**User Guide**Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your
freezer be provided. Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
Water Pressure
A cold water supply with water pressure of between 30 and 120 psi (207 to 827
kPa) is required to operate the water dispenser and ice maker. If you have
questions about your water pressure, see “Troubleshooting” or call
a licensed, qualified plumber.
Reverse Osmosis Water Supply
If a reverse osmosis water filtration system is connected to your cold water
supply, the water pressure to the system needs to be a minimum of 40 to 60 psi
(276 to 414 kPa).
PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
IMPORTANT : Do not install the freezer near an oven, radiator, or other
heat source, nor in a location where the temperature will fall below 40°F
(5°C).
Check the strength of the floor before installing your freezer. It should hold
the weight of a freezer fully loaded with food.
Allow at least 3″ (7.5 cm) of air space at the top and on both sides of the
freezer and 1″ (2.5 cm) between the back of the freezer and the wall.
If the freezer is to be against a wall, leave extra space on the hinge side so
the door can open wider.
NOTE : This freezer may be installed side by side with another
refrigerator or freezer. Allow for a 3″ (7.5 cm) clearance at the top and
sides and a 1⁄4″ (0.64 cm) clearance between the appliances.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10668404A
9/19/14