MOVO WMIC50 Wireless Microphone User Manual
- June 16, 2024
- MOVO
Table of Contents
WMIC50 Wireless Microphone
Instruction Manual
The MOVO WMICSO Wireless microphone is Compact, high performance, lightweight
and compatible with DSLR cameras, Camcorders, Audio recorder etc.
It consists of a transmitter, receiver, two piece of earphone(one is with
speaker), an audio signal cable, a lavalier/lapel microphone.
**** 1- year warranty
How to use It
Insert battorlen in the Lratvaniittar and racalver waite
- Both transmitter and receiver requires two Lft03/AAA size batterias
- Siide and cernaves thes Crarernaitter ‘s halter y Larned tent Clive
- Insert two batteries
- Close the battery Compartment cover,
- Do the annie ways as step 2 to 4 to insert battery into reciver.
Precautionary measures when using batteries
Battelles/powar packs, If inappforintoly handled, ten run out or walada , Mancha imerm the following notes on lately when handling batteries to be used In the device.
- Use only batteries montlond In time operating Instructions,
- Do not lay the ballades ins ere and do not expose them to direct heat,
- In coder to avoid damage to the product you must make sure that you remove the batteolos, It you do not use the product over a longer pearled of Urns or If the batteries have been discharged,
- If battery nuld cones Into contact with skin or clothes, rinse It off Immediately with fresh water
- Please read these Istructions for use thoroughly before you use this new equipment for the first time. lt contains averything you need to know In order to avoid damage to persons or property.
- Strictly follow all notes on safety In these Instructions for use.
- Keep these instructions for use in o safe place, If you sell you equipment or pass it on to someone else, you should also pass on these instructions for use.
Connecting the transmitter and receiver
Receiver
- Mount receiver to camera.
- Insert the straight plug of the connecting cable into the receiver “LINE OUT” jack.
- Insert the other plug of the connecting cable into camera “MIC” socket.
- Insert earphone ( the one with speaker) into receiver * ”.
- Slider the power ON/OFF switch to ON position ( the LED indicator will light in green)
Transmitter
- Insert the earphone ( the one without speaker) into transmitter “ “.
- Insert the lavalier/lapel microphone into transmitter “ ”.
- Slider the power ON/OFF switch to ON position ( the LED indicator will light in green).
- The belt clip on the back of the unit clips the transmitter onto a belt, or the transmitter simply can be put into a pocket.
If transmitter and receiver connect, the light will flash every 2.5 seconds.
Otherwise, the light will flash rapidly.
Before leaving factory, the connection of both of transmitter and receiver
will be established.
How to connect transmitter and receiver ’
- Turn on the receiver
- Press the button VOLUME “+” and “-“ for 3 seconds at the same time.
- Repeat steps 1 to 2 steps to set up the transmitter.
Status of the communication indicator
Status | Receiver | Transmitter |
---|---|---|
Unit is turned ON | Flashing | |
Wireless communication is established | Flashing continually every 2.5 seconds | |
Receiver unit is turned OFF(Transmltter is still ON) | Off | Flashing |
Transmitter unit is turned OFF(Receiver is still ON) | Flashing | Off |
Low power | Flashing in red |
Specifications
-
RF Modulation: GFSK (Gauss frequency Shift Keying)
-
Frequency band: 2.4GHz (2405-2478MHz)
-
Frequency response: 35Hz-14KHz+3dB
-
Signal/Noise: 76dB or more
-
Distortion: 0.1% or less (322,1 KHz,65mW output)
-
RF output level:S mW
-
Earphone output level: 322,65mW
-
Reception sensitivity: -85dB +/- 3dB / OdB= 1V/Pa, 1kHz
-
Audio input connector: 3.5mm mini jack
-
Operation range: 50m (164ft.)
-
Power requirements: 3.0V DC (Two LRO3/AAA size batteries)
-
Consumption power:Transmitter: 3.3V/110 mA
Receiver: 3.3V/100 mA -
Battery life:Transmitter: Approx. 3.5 hours
Receiver: Approx. 4 hours -
Dimensions: Transmitter: 60mm x 86mm x28mm (W/H/D) (2.36 x 3.3 x 1.1 inches)
Receiver: 60mm x 86mm x41mm (W/H/D) (2.36 x 3.3 x 1.61 inches) -
Weight: Transmitter: 1369 (4.370z) (Without battery)
Receiver: 152g (4.890z) (Without battery)
CAUTION
- Please use our original Audio Signal Cable which is equipped, it’s more compatible with the wireless microphone, and make the sound better.
- The figure given is only the approximate value that applies when there are no obstructions between the transmitter and receiver. This distance will vary depending on meta! objects, people and other obstructions and on the signal strength.
- Battery life may vary depending on the type of battery used.
IMPORTANT
- If you do not intend to use the wireless microphone for a long period time, please remove the batteries from both the transmitter and receiver.
- Do not touch the lavalier/lapel microphone, transmitter and receiver while recording, as this will cause noise to be recorded.
- Do not let the transmitter close to high-voltage equipment or to devices that emit strong electromagnetic fields, otherwise, it may cause the noise to be recorded.
- Do not use or leave the transmitter and receiver in hot, humid places.
- Do not leave the receiver attached to the camera when storing the camera in a case.
- Do not mix up to use the transmitter and receiver.
MAINTENANCE
- Do not operate the device with wet hands or feet.
- Clean the equipment only in the way described in the instructions for use.
- Take care to prevent the equipment from dropping down.Make sure that the device is properly fastened and reliably mounted. If the device has dropped down on the floor have it inspected by a skilled electrician before you switch it on again.
- Should the equipment be damaged or defective,or if you notice a scorching smell: Interrupt the electric power supply immediately by removing the batteries.Do not operate the device with a damaged housing,do not repair the device yourself. Have the device only repaired by a skilled electrician.
- Always keep your device in good condition,as specified in these in-structions for use.
- Do not open the device.
WARNING
- Keep the wireless microphone out of the reach of children.
- Never use leaking batteries and never expose batteries to excessive heat or fire.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>