PERFECT AIRE 1PED30 Dehumidifier User Manual

COMFORT…BUILT TO LAST
30, 50 & 70 PINT
DEHUMIDIFIER USER MANUAL FOR MODELS:
1PED30/1PED50
1PED50S/1PED70

1PED30 Dehumidifier

Before using your dehumidifier, please read this manual carefully and keep it for future reference, along with your receipt.

Quick Start Tips

It is highly suggested that the manual be read in full before operating the unit. However, the notes below are especially important in helping you to properly set up and begin to use your dehumidfiier.

1. The dehumidifier should be kept upright. If for any reason it has not been stored upright while in your possession, set the unit in the upright position for a minimum of 24 hours before initial start.

2. Press the POWER button to turn the dehumidifier ON.

3. Using the + and – buttons, set the humidity to 30%RH for the first 24 hours of operation.

4. After the 24 hours, set the desired humidity using the + and – buttons.
   Recommended humidity is between 45~55%RH.

5. For Model Numbers 1PED50 and 1PED70, when unpacking the dehumidifier, note that the foam inside the float of the bucket should NOT be removed.
   Without this foam piece, the dehumidifier will not operate properly.
   (Model Numbers 1PED30 and 1PED50S do not require this foam piece.)

6. The accessories are located in the packaging as follows:

4x Castors

• Found in bucket for Model Numbers 1PED30 & 1PED50S
• Castors are already installed on Model Numbers 1PED50 & 1PED70

**** Electrical waste products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

CAUTION

• Contact an authorized service technician for repair or maintenance of this unit.
• Contact an installer for installation of this unit if necessary.
• The dehumidifier is not intended for use by children without adult supervision. Children should be supervised by an adult to ensure that they do not play with the dehumidifier.
• Disabled persons may require assistance with set up and usage of this unit.
• If the power cord is to be replaced, replacement work should be performed by authorized technician only.
• Installation and repair work must be performed in accordance with the national wiring standards by authorized personnel only.

NOTE: All the illustrations in this manual are for explanation purposes only. Unit purchased may be slightly different.
The design and specifications are subject to change without prior notice for product improvement. Contact consumer services at 844.472.2473 for details.

ELECTRICAL INFORMATION

• The manufacturers nameplate is located on the rear panel of the unit and contains electrical and other technical data specific to this unit.
• Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is equipped with a three-prong grounding plug for protection against shock hazards. Do not remove the third prong.
• The unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install a proper receptacle.
• Ensure the receptacle is accessible after the unit is installed.
• Do not use extension cords or adapter plugs with this unit. However, if it is necessary to use an extension cord, use an approved dehumidifier extension cord only (available at most local hardware stores).
• To avoid the possibility of personal injury, always disconnect the power supply to the unit before installing and/or servicing.

SAFETY PRECAUTIONS

WARNING

● Do not fold the power cord as shown below!

● Make sure the plug is pushed fully & firmly into the outlet!● Do not use an outlet splitter as shown below! ● Make sure the plug is clean! ● After turning the unit off, please take the plug out of the socket. ● Do not grab power plug with wet hands.

CAUTIONS
● Do not place anything on top of the control panel!

● Do not place anything over or on the inlet or outlet of the unit. ● Do not let children play with or around the unit or control panel!

● Do not wet the machine or the control panel! ● Keep flammable gas/oil away from the machine! ● Ask a professional if servicing is necessary! ● Do not pull from the power cord to avoid damaging the cord. ● Do not use insect, oil, or paint spray around the machine as it may cause damage to the unit or start a fire.

● Do not place the unit on an uneven surface in order to avoid shaking, excessive noise, and water leakage.

● Always keep the unit 8″ away from the wall to dissipate the heat properly. 8″ of space on all sides is recommended.

● Do not pour anything into the unit.

● Close all windows and doors in order to efficiently remove the maximum amount of moisture.

● Keep the machine away from any type of heat source and direct sunlight.

● When moving or storing, do not place the dehumidifier on its side or upside down and avoid shaking.

DESCRIPTION OF COMPONENTS

CASTOR INSTALLATION

Castor installation is recommended to avoid damage to floors. Model Numbers 1PED50 and 1PED70 have castors already installed.
However, Model Numbers 1PED30 and 1PED50S require castors to be installed after unpacking the unit using the instructions below.
Castors for the 1PED30 and 1PED50S Models can be found in the bucket when unpacking the unit for the first time.

1. Remove the castors from the bucket of the dehumidifier.
2. Position the dehumidifier on its side.
3. Locate the arrow on the bottom of the dehumidifier and insert the castor according in the direction of the arrow.
4. Slide the castor in as far as it will go. The castor will snap into place once secure.
5. Repeat steps 1 through 4 for the remaining 3 castors.
6. To remove castor, press tab down and slide the castor out.

*NOTE: Wait 24 hours before running unit.

FUNCTION EXPLANATION

1. Bucket Full Light
   Bucket is full, and lamp
   illuminates.

2. Defrost Light
   When low temperature, unit gets into “Defrosting” mode and lamp illuminates. When the coils have accumulated frost, the unit will go into auto defrost mode.

3. Power
   On/Off

4. Fan Speed
   High/Low

5. Timer
   The timer can be set to run between 1 and 24 hours.
   • When unit is in operation, press “TIMER” and then “+” or “—” to set hours (TIMER OFF will be illuminated). The unit will turn off after set hours.
   • When the unit is on stand-by, press “TIMER” and then “+’or “—” to set hours.
   The unit will turn on after set hours {TIMER ON will be illuminated).
   • To cancel the timer, proceed as above, but set both TIMER ON and TIMER OFF to zero hours. Both lights for TIMER ON and TIMER OFF should be off.

6. current Humidity/Timer & Humidity Set Display
   When the unit is running, it displays the current room humidity. Press “TIMER”; the set hours are displayed here. 10 seconds after displaying the timer, the display will change back to the room humidity.

7. Set Humidity/Timer (+/-)
   Setting Desired Humidity: When the unit is running, it displays current room humidity (%RH). Press “+” or “—” to select desired humidity setting. The humidity is adjusted in increments of 5% with each press of “+” or “—”, Adjustable range is 30%RH — 90%RH. A few seconds after setting the desired humidity, the display will go back to the current humidity.
   Setting Timer: To set timer, follow instructions in the Timer section.

8. Filter Reset Button
   After 250 hours of operations, the filter indicator light will illuminate to remind you to clean the air filter. Press this button to reset the air filter timer and to turn off the “Check Filter” indicator after cleaning the filter.

OPERATING INSTRUCTIONS

● Start Operation

1. Ensure that the unit is plugged into a properly designated power outlet.
2. Insert the plug into a suitable wall outlet. The dehumidifier is suitable for operation on an electricity supply having the same voltage as that shown on its rating label.
3. Place the unit in an upright position on a flat, level, steady, stable, heat-resistant surface. Make sure there is nothing flammable or heat sensitive within 39 inches (100 cm) of the unit. Operating the unit in any other position is hazardous.
4. Make sure the bucket is placed in the proper position.
   (After switching the unit on for the first time, the “Bucket Full” light may illuminate. Pull the bucket out, check that the “float” lever is able to move freely, then push the bucket back to the proper position.)

●When Bucket Full Light Is On
When the bucket is full, the unit will stop running, beep 5 times, and the “Bucket Full” light will illuminate. To empty the bucket, carefully slide the bucket out from the bottom front of the unit.
Hold the bucket with both hands to avoid spilling. Once the bucket has been emptied, return the bucket to its proper position by sliding the empty bucket back into place. The unit will start up and run normally.

● DEFROST
When operating in low temperatures (less than 54°F/12°C) the surface of the evaporator may accumulate frost and effect the efficiency of the dehumidifier.
When this happens, the unit will automatically go into “Defrost” mode. This is normal and the “Defrost” light will illuminate. Once the unit is done defrosting, it will resume running as normal. The unit can operate in temperatures down to 41° F/5°C. Defrost times may vary. If the dehumidifier freezes up, turn the unit off for a few hours and then restart. It is not recommended to use the dehumidifier in temperatures below 41°F/5°C.

CONTINUOUS DRAINAGE

1. To save having to periodically empty the bucket, this unit can be set for continuous drainage. Use the supplied drain hoseonnect  to the continuous drainage connector located on the back righthand side of the unit..|
---|---
2. Unscrew and remove the drain cover found at the rear of the unit.|
3. Remove the soft rubber stopper. Place it in the bucket for safe keeping.
4. Return the bucket to its proper position.|
5. Insert the drain hose (provided) through the hole of the drain cover with the washer portion on the inside of the cover.|
6. Connect the drain hose to the drain port.|
7. Tighten the drain cover in clockwise direction onto the rear of the unit.|

INSTALLING DRAINAGE GARDEN HOSE
When using the “Continuous Drainage” function, a regular garden hose can be used in place of the drain hose provided. Avoid uneven ground and folding of the hose. The hose should go on a downward slope and be free of folds/kinks in order to properly drain into the drain hole. The hose length should not exceed 6 ft.

MAINTENANCE

For safety reasons, make sure the dehumidifier is unplugged before servicing or cleaning.

1. Cleaning the unit:
   A. Wipe the unit with a clean, soft cloth.
   B. If the dehumidifier is very dirty, use a moist cloth with a mild detergent to clean, then wipe off the detergent with a semi-dry cloth.

CAUTION: Do not wash the machine with a hose or immerse it in water. This may result in electrocution.

Cleaning the air filter:
The purpose of the air filter is to filter dust and other materials from the air. If the filter is blocked with dust, the electricity usage will be higher than normal. For optimal moisture removal and efficiency, clean the filter every 2 weeks.

● Cleaning Steps:

1. Remove and empty bucket.
2. Pull the air filter out gently from the bottom of the front panel.
3. Clean the filter with a vacuum cleaner or wash it with clean, luke warm water and dry with a dry cloth.
4. Put the clean air filter back in place and continue to operate the dehumidifier.

EMERGENCY ****

If a problem occurs, unplug the machine and contact consumer services at 844.472.2473.
Do not disassemble the dehumidifier yourself!

TROUBLESHOOTING TIPS

Before calling for service, review the chart below first.

into the outlet.
• Check the house fuse/circuit breaker box.
• Dehumidifier has reached its preset level or bucket is full.
• Water bucket is not in the proper position.
• Unit is set to a humidity level that is higher than the current humidity level in the room.
Dehumidifier does not dry the air as it should| • Did not allow enough time to remove the moisture.
• Make sure there are no obstructions such as curtains, blinds or furniture blocking the front or back of the dehumidifier.
• The humidity control may not be set low enough.
• Check that all doors, windows and other openings are securely closed and that room is not too large.
• Room temperature is too low, below 5°C (41 °F).
• There is a kerosene heater or other device giving off water vapor in the room.
The unit makes a loud noise when operating| • The air filter is clogged.
• The unit is tilted instead of upright as it should be.
• The floor surface is not level.
Frost appears on the coils| • This is normal. The dehumidifier has Auto Defrost feature.
Water on floor| • Hose to connector or hose connection may be loose.
• Ensure back drain plug on bucket is in place and secure.
• Make sure the float is in place.
E1, E2, E3 and EC appear in the display| • These are error codes and protection code. See the CONTROL PAD ON THE DEHUMIDIFIER section on pg 4.
Continuous drain does not work| • Check that entire connection is secure and accurate.
• Check that the unit is level.
• Check that the hose is clear of kinks and is not blocked.

If these steps do not resolve the issue, call 844-472-2473 for assistance before returning unit to the store.

COMFORT…BUILT TO LAST
Distributed by:
Perfect Aire, LLC
5151 Belt Line Rd.
Suite 878
Dallas, TX 75254
844-472-2473
www.perfectaire.us

Specification and performance data is subject to change without notice.
Printed in China

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>