Maxi-Cosi 014805201B Pebble 360 Pro baby car seat Instruction Manual
- June 16, 2024
- MAXI-COSI
Table of Contents
Maxi-Cosi 014805201B Pebble 360 Pro baby car seat
Product Information
Specifications
- Product Name: Pebble 360 Pro
- Dimensions: 40-87cm
- Maximum Weight Capacity: 13 kg
- Age Range: 0-15 months
- Manufacturer: Maxi-Cosi
- i-Size compliant
Product Usage Instructions
Installation
The Pebble 360 Pro can be installed using either a Maxi-Cosi ISOFIX base or
the 3-point safety belt of your car. Please follow the appropriate
instructions for installation.
Installing with Maxi-Cosi ISOFIX Base
Please refer to the user manual of the Maxi-Cosi ISOFIX base for detailed
instructions on how to install the Pebble 360 Pro. Ensure that the base is
securely attached and follow all safety guidelines.
Installing with 3-Point Safety Belt
If you choose to install the Pebble 360 Pro using the 3-point safety belt of
your car, follow these steps:
- Place the Pebble 360 Pro in the desired seating position in your car.
- Ensure that the seat belt is not twisted and securely fasten it around the base of the Pebble 360 Pro.
- Adjust the seat belt tension to ensure a tight and secure fit.
Usage
Once the Pebble 360 Pro is properly installed, follow these guidelines for
usage:
Buckle Up
Ensure that your child is securely buckled up in the Pebble 360 Pro before
every car journey. Make sure the harness straps are properly adjusted and
tightened for a snug fit.
Adjusting the Headrest
The headrest of the Pebble 360 Pro can be adjusted to accommodate your child’s
height. Simply pull up or push down on the headrest to adjust it to the
desired position.
Removing the Pebble 360 Pro
To remove the Pebble 360 Pro from your car, follow these steps:
- Unbuckle your child and remove any blankets or accessories.
- Press the release button located at the back of the Pebble 360 Pro.
- Lift the Pebble 360 Pro out of the car seat base or release it from the safety belt.
FAQ
Q: Can I use the Pebble 360 Pro with any car?
A: The Pebble 360 Pro is classified for Universal use and can be fixed into
the seat position of most cars. For a complete list of compatible cars, please
visit our website at www.maxi-cosi.com/car-fitting-list.
Caution
The quick start guide is intended to provide only an overview. For the maximum protection and comfort of your child, you must read through the entire manual carefully and follow all instructions.
Quick start guide
Pebble 360 Pro is a Universal Belted Enhanced Child Restraint System. It is approved according to UN Regulation No. 129 i-Size, for use primarily in “Universal seating positions” as indicated by vehicle manufacturers in the vehicle user’s manual. If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer. This infant car seat is part of the 360 Pro Family providing a full mobility solution from birth until approx. 4 years. To learn more about i-Size, please connect to the website www.maxi- cosi.com.
- Category of your car seat: i-Size (40 cm-87 cm – up to approx. 15 months)
- Position of your car seat: rearward facing
The Pebble 360 Pro can be installed on a Maxi-Cosi ISOFIX base. Please make sure you read the user manual of this base carefully. Alternatively, the Pebble 360 Pro can be installed by using the 3-point safety belt of your car.
This child restraint is classified for “Universal” use and is suitable for fixing into the seat position of the following cars:
IMPORTANT:
For a complete list of cars, please visit www.maxi-cosi.com/car-fitting-
list.
INSTRUCTIONS FOR USE
Recline
Carrying handle
- A1: Carrying and driving position
- A2: Release and installation position for child
- A3: Stable standing position for use outside the car
Ready to go
Option A
Option B
Child installation
Stroller & car seat
Airplane installation
Washing Or Cleaning
Product Description
- A – Carrying handle
- B – XL Sun canopy (built-in)
- C – Push buttons for carrying handle adjustment (L+R)
- D – Belt hooks for lap part of belt (L+R)
- E – Belt buckle with belt pad
- F – Harness adjuster button
- G – Storage compartment for user manual
- H – Harness belt tensioner strap
- I – Cover
- J – Newborn inlay
- K – Easy-in shoulder belts with removable belt pads
- L – Stroller release buttons (L+R)
- M – Height adjustable headrest
- N – Headrest height adjustment handle
- O – Recline handle
- P – Belt hook for shoulder part of the belt
- Q – Mounting bars for base
SAFETY
- The car seat is developed for an intensive use of approximately 6 years.
- Do not leave your child unattended in the car. With an outside temperature of 20 degrees, the car interior heats up in 20 minutes to 40 degrees Celsius which causes a risk. To prevent the risk of overheating consider a Child reminder device e.g. Maxi-Cosi e-Safety inlay cushion.
Pebble 360 Pro car use
- The car seat can be rotated and slid in and out of the car by installing it on the Maxi-Cosi FamilyFix 360 Pro rotative base. It helps you to get your child in and out of the vehicle easily.
- When the car safety belt is used, make sure the car safety belt buckle runs in a straight line and stays below the belt hook of the car seat.
- The car safety belt must be threaded tight along all green markings. For a proper installation, check the instructions in this manual and the sticker on the side of the car seat.
- Only use a forward-facing seat that is fitted with a 3-point safety belt that complies with the ECE R16 standard.
- When the child restraint is installed in the maximum rearward-facing position, it may not fit in all approved vehicles. Please check that all possible positions of the car seat (recline positions and headrest adjustment) fit in your car.
WARNING:
-
Never close your car door with the FamilyFix 360 Pro in a slided-out position.
-
Install the car seat only rearward-facing in the car on a forward-facing vehicle seat.
-
The car seat must always be locked in the rearward-facing position when travelling. Do NOT travel when the car seat is rotated to a lateral (loading) position or to any other unlocked intermediate position.
-
Pebble 360 Pro and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Make sure the headrest is adjusted to the proper height. -
Make sure that the shoulder harness belts are at the correct height. The shoulder harness belts should be on or just below the baby’s shoulders.
-
The newborn inlay included in your Pebble 360 Pro seat is exclusively for use with the Pebble 360 Pro and plays an integral part in the safety of the restraint system for your child from 40 to 60 cm. The newborn inlay is removable and the cover can be taken off for washing; it is essential to place it back again where it belongs and only use this official Maxi-Cosi Pebble 360 Pro newborn inlay.
-
Only use the newborn inlay of the Pebble 360 Pro until your baby exceeds the 60 cm length limit. Afterwards, remove the newborn inlay from the Pebble 360 Pro.
WARNING:
- Never place the car seat on an elevated surface (such as a table or chair).
- It is prohibited to adjust the seat position while travelling.
Using Pebble 360 Pro
- When Pebble 360 Pro is installed on a stroller, always make sure to use approved car seat adapters and to secure Pebble 360 Pro correctly.
- The height of the headrest and the shoulder harness can be set simultaneously into different positions. Pull the headrest adjustment strap and meanwhile, pull up or push down the headrest until it’s in the correct position.
Pebble 360 Pro in airplanes
- Installation of the Pebble 360 Pro on an aircraft seat differs from the installation on a car seat.
- Installing the Pebble 360 Pro with a 2-point safety belt is only allowed when used in an aircraft.
- In an aircraft, the Pebble 360 Pro may only be used on forward-facing passenger seats.
- To install Pebble 360 Pro, place the infant carrier rearward facing on the passenger seat. Route the webbing of the 2-point safety belt through the belt guides. (1,2) Lock the buckle of the 2-point safety belt. (3) And tighten the 2-point safety belt by pulling on the tightening strap. (4)
- The handle of the Pebble 360 Pro must be in an upright position.
- The belt buckle must not be positioned between the belt hooks of this car seat. Otherwise, a safe attachment does not exist.
- To uninstall Pebble 360 Pro, open the buckle of the 2-point safety belt by lifting the lever of the buckle. (5) And remove the webbing of the 2-point safety belt from the guides. Make sure the Pebble 360 Pro does not fall from the passenger seat when opening the buckle.
- The Pebble 360 Pro must remain belted on the aircraft seat, even when unoccupied.
- The Pebble 360 Pro is only for use on an aircraft seat authorized by the airline.
- Do not install the Pebble 360 Pro in the area of airbag deployment.
- Instructions of the cabin crew must be followed.
- The safety of your child for not complying with the installation and instruction manual is not guaranteed.
CARE
- The cover, inlay, belt pads and sun canopy of the car seat can be removed for washing. The front baleen of the sun canopy needs to be removed before washing. The harness webbing can be cleaned by using a wet cloth.
- The plastic inserts of the shoulder pads do not need to be removed before washing.
Non-contractual photos
Contact Information
-
DOREL FRANCE S.A.S.
Z.I. – 9 bd du Poitou BP 905 49309 Cholet Cedex FRANCE -
DOREL EUROPE B.V.
P.O. Box 6071 5700 ET Helmond NEDERLAND -
DOREL (U.K.) LTD
Imperial Place 4 Maxwell Road Borehamwood Hertfordshire WD6 1JN UNITED KINGDOM -
DOREL GERMANY GMBH
Lintgasse 9 D-50667 Köln DEUTSCHLAND -
DOREL ITALIA S.P.A.
Via Verdi, 14 24060 Telgate (BG) ITALIA -
DOREL HISPANIA S.A.U.
Edificio Barcelona Moda Centre Ronda Maiols, 1 Planta 3ª, local 340 08192 Sant Quirze del Vallès ESPAÑA -
DOREL PORTUGAL
Rua Pedro Dias, 25 4480-614 Rio Mau (VDC) PORTUGAL -
DOREL JUVENILE
SWITZERLAND S.A. Chemin de la Colice 4 1023 Crissier SWITZERLAND/SUISSE -
DOREL POLSKA Sp. z o.o.
ul. Inwestycyjna 14 41-208 Sosnowiec POLAND
References
- Car seat Advisory Tool | Maxi-Cosi
- Car Seats & Baby Gear | Safety 1st, Maxi-Cosi, Cosco Kids, Tiny Love – Dorel Juvenile
- Car seat Advisory Tool | Maxi-Cosi
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>