DawnSun FA0158A Remote Control Transmitter Instruction Manual
- June 16, 2024
- DAWNSUN
Table of Contents
OPERATION INSTRUCTION
FA0158A Remote Control Transmitter
MODEL:
FA0158A
FA0158 -DA Note: Install the 12-volt battery to the
remote control.
Remote Control Functions:
- FAN ON/OFF Button: Turn the fan on or off
- Fan speed HIGH.
- Fan speed MEDIUM.
- Fan speed LOW.
- LIGHT ON/OFF/DIMMING Button: To control light on/off/dimming.
- Walk Away Delay Off B
- Nature Breeze Button.
- Home Shield Button.
- Extended Function Switch L.
Remote Control Functions:
- FAN ON/OFF Button: Turn the fan on or off.
- Fan speed HIGH.
- Fan speed MEDIUM.
- Fan speed LOW.
- LIGHT ON/OFF/DIMMING Button: To control light on/off/dimming.
- Walk Away Delay Off B
- Nature Breeze Button.
- Home Shield Button.
- Extended Function Switch L.
- Extended Function Switch R.
- Extended Function Switch C.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this device does cause harmful interference to radio or television
reception, which can be determined by turning the device off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>