ZUMA Lumisonic and Luminaire Flush Mount Kit Installation Guide
- June 9, 2024
- ZUMA
Table of Contents
ZUMA Lumisonic and Luminaire Flush Mount Kit
Introduction
Thank you for purchasing your Zuma Flush Mount Adapter (Round). Here you’ll find a quick guide to help you get started. Enjoy!
You will need
-
3 plasterboard screws
- 12cm hole saw
Installation
-
Drilling holes
Begin by using a 12cm hole saw to cut holes in your ceiling where you intend to install your Zuma Flush Mount adapters. -
Insert the Flush Mount Adapter
Bring the Flush Mount Adapter to the ceiling and carefully push it into the hole. -
Screw into the ceiling
- Using #3 plasterboard screws, secure the Flush Mount Adapter to the ceiling.
- Ensure there is some batten inside of the ceiling for the screws to grip onto.
SECTION VIEW
-
Plaster the ceiling
Apply plaster skin on the ceiling to cover the mounting face.
SECTION VIEW -
Remove the plug
- Once the plaster skin has set and the ceiling has been painted, remove the protective plug and discard it. You are now ready to install your Zuma unit.
- Please refer to the Zuma Installer Guide for instructions on how to install your Zuma unit. SECTION VIEW
-
Install the Zuma unit
Refer to the Zuma Installer Guide for instructions on how to install your Zuma unit.
To review your warranty coverage, please visit www.zuma.ai.
2021 ZUMA Array Limited or its affiliates.
Zuma and all related logos are trademarks of Zuma Array Limited or its
affiliates.
The registered office of Zuma Array Limited is:
5 Garden Walk, London, United Kingdom, EC2A 3EQ.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>