Dawnsun Electronic Technology Zhongshan TX00I-R1 Remote Control Transmitter Instruction Manual

Dawnsun Electronic Technology Zhongshan TX00I-R1 Remote Control

Transmitter

MODEL:
TX00I-R1
TX00 I-R2
TX00 I-R3

OVER VIEW

Remote Control Functions

1. Fan speed control button To control the ceiling fan speed HIGH MEDIUM,LOW.
2. FAN/OFF button:
   • Turn off the fan;
   • Press and hold for 5 seconds to enter Light Delay Off mode.
3. LIGHT ON/OFF/DIMMER button To control light on,off and dimming.
4. Extended Function Switch: 1/0(Optional).
5. Extended Function Switch: D/CFL (Optional).
6. Extended Function Switch: Learn(Optional).

Note: Install the 12-volt battery to the remote control.

OPERATION INSTRUCTION

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
2. This device may not cause harmful interference
3. This device must accept any interference received, including interference that may cause undesired operation.
4. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

IC STATEMENT
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Products shall be subject to any changes without additional notices due to DawnSun will keep innovation and optimization on the products.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>