LURKER V240 White Liquid CPU Cooler User Manual

LURKER V240 White Liquid CPU Cooler

Package Included

Preparation before installation (intel/AMD)

• Tear off the protective film on the water cooler before installation

• Squeeze an appropriate amount of thermal paste in the middle of the CPU

• Spread the thermal grease evenly with a silicone grease spoon

INSTALLATION

INTEL

• Tear off the double-sided adhesive film on the back panel

• Adjust four corners of the backplane to the corresponding positions according to your motherboard

• Align the screws of four corners on the backplane with motherboard holes and install

• Align the intel mounting bracket with the product’s hole first, and then lock it with screws grease spoon

• Align the intel 1200/115X bolts with the hole on the back plate and tighten it

• Place the water block on the CPU of the motherboard as shown in the right picture

• After aligning the holes, turn the mounting nut to the direction of the figure → until it cannot be turned

• Align the Intel 1700 bolts with the stud hole on the back plate and tighten it

• Place the water block on the CPU of the motherboard as shown in the right picture

• After alignin thil it cas, torme turmounting nut to the direction.

• Align the Intel 20XX bolts with the stud hole on the back plate and tighten it

• Place the water block on the CPU of the motherboard as shown in the right picture

• After aligning the holes, turn the mounting nut to the direction of the figure → until it cannot be turned

AMD

• Align the AMD mounting bracket with the product hole first, and then lock it with mount bracket screws

• Fix the AMD mounting screw and mounting nut on the mounting bracket (no need to tighten)

• Pass the AMD bolts through the motherboard bracket and then tighten with mounting nut

PWM Cable Connection

1. Connect the pump cable to CPU FAN interface of motherboard
2. Connect 4pin cable of fans with 1 to 2 fan splitter cable, and then connect the spliter cable to SYS FAN interface of motherboard.

Lighting Cable Connection

(The motherboard does not support 5V Spin interface)

• Step 1

  • Connect the 5v Spin cable of pump and fans to controller pin Interface
  • Connect the SATA interface of the controller to the SATA interface of the compuber power supply
  • Connect the 2pin interface of the controller to the case reset or LED button, and manually press the button to control the light effect

• Step 2

1. Connect the 5v Spin cable of pump and fans to controller Spin Interlace
2. Connect the SATA interface of the controller to the SATA interface of the computer power supply  

Connect the ARGB synchronization cable of controller to the 5V 3pin interlace of the motherboard to control lighting effects synchronously on the motherboard

• Step 3
  Connect the male and female intertaces of the pump lighting cable and the fan lighting cable in series and then connect to the 5V Spin interface of motherboard

Controller Instructions

1. Lignby press the mode button to freely switch between 20 Ighung effects;
2. Long press the mode button for 3 seconds, the white lighting of the controller will flash once, and it will enter the motherboard mode;
3. Long press the mode button for & seconds, the white lighting of the controller flashes twice, and it enters the lighting off mode;
4. If the 2 pin interface of the controller is connected to the PC case reset bution, the reset button cen replace the mode bution of the controller

Radiator Instructions

1. Fix the fans on the radiator with screws (as shown on the left
2. Lock the radiator with the fans on the computer case (as shown on the right.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>