TYLT 2AOAF-7302 Hydration Bottle Plus Power Bank Charger User Guide
- June 16, 2024
- TYLT
Table of Contents
2AOAF-7302 Hydration Bottle Plus Power Bank Charger
User Guide
2AOAF-7302 Hydration Bottle Plus Power Bank Charger
- Totally dust tight. Full protection against dust and other particulates, including a vacuum seal, tested against continuous airflow. Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects).
Limited 1 year warranty. To receive a free 1 year warranty extension (2 years total), register your product at: www.Tylt.com/warranty iPhone is a trademark of Apple Inc., registered in the U.S. and other countries.
Samsung is a trademark of Samsung Electronics Co, Ltd. Other marks are the property of their respective owners. © 2022 Tylt. Tylt and the logo are trademarks of Tylt Inc. Made in China. Designed in the U.S.A. in Simi Valley, CA. C3875
bottle2.0
Hydration Bottle + Power Bank + Wireless Charger
Wireless Charging
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.”
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
Bottle2.0
- Cap It has a wide mouth design.
- Lanyard Easy transportation.
- Thermal Bottle Double layer vacuum insulation keeps 24 oz of liquid hot or cold for up to 12 hours. The inside is stainless steel grade 314 anti-corrosion.
- Cable Storage The cable and cable storage space are located above the battery.
- Removable Battery 5, 700 mAh capacity. Wired and wireless charging give up to two full charges.
- Power Button Turn t on or off.
- LED Light Blinking white light indicates charging.
- Charging Ports Located on the back of the battery.
Caution
- Careful. The beverage you are about to enjoy may be very hot. Always use caution.
- DO NOT wash the battery. Always unscrew the battery first before washing the bottle.
- If filling with boiling liquid, allow liquid to cool with the cap OFF for at least 3 minutes.
- DO NOT microwave or freeze.
- DO NOT use harsh chemicals to clean the bottle or battery such as bleach, chlorine and I or abrasives.
Cleaning Instructions
- Wash thoroughly before first use.
- Hand wash ONLY. Remove the battery first, then soak the cap for 10 minutes in hot, soapy water. Wash bottle with warm water and mild detergent. Rinse the cap and bottle before use.
- DO NOT wash or submerge the battery in water.
- Clean the battery with a damp cloth, while the port cover is closed.
- Always store the bottle with the cap removed to allow the parts to completely dry.
| Blak | ATIN: TYLT, INC. | DIMENSIONS: 70mm x 70mm | DATE: 04/18/22 |
|---|---|---|---|
| PRODUCT: Bottle Hang Tag | MATERIAL: 20PT SBS |
please proofread all copy I not a color proof 1.877 .524.2525 www.blakinc.com
These designs are representative of information architecture, indicating
priority and layout of page components. or feel of the design. PREPARED FOR
TYLT CONTACT
Pawnie Farshi
pawnie@blakinc.com
877-524-2525 Ext. 701
2238_Bottle 2_Hang Tag_fn
04/18/22 / © 2022 Blak Inc. /
www.blakinc.comwww.TYLTcom