VEX ROBOTICS 280-7125 EXP Robot Brain Instruction Manual
- June 5, 2024
- VEX ROBOTICS
Table of Contents
VEX ROBOTICS 280-7125 EXP Robot Brain
INSTRUCTION
- Backlit LCD
- Check Button
- (8x)3-Wire Port
- button
- (10x) Smart Port
- Left&Right Buttons
- Structure Mounting
- Battery Slot
- Speaker
- USB Port
- MicroSD Slot
To turn on Robot Brain. Press the check button. To turn off Robot Brain, press the X button
PLEASE KEEP THESE INSTRUCTIONS
To install Robot Battery:
(280-7126 sold separately) Slide Robot Battery into Robot Brain.
To remove Robot Battery:
Depress battery latch and pull out the battery.
To pair Robot Brain and Controller 280-7729:
- On the Robot Brain go to Settings
- Navigate to “Pair Controller”
- Follow onscreen instructions to pair
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. these limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, it, not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which çan be determined by turning the equipment off and on. the user is encouraged to try tO Correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Shielded cables must be used with this unit to ensure. compliance with the Class BECClimits.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement: This device complies with part 5 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>