ASD Black 4 Inch LED Recessed Lighting Retrofit Square User Guide

: June 16, 2024
: ASD

Table of Contents

Read User Manual Online (PDF format)
Download This Manual (PDF format)

ASD Black 4 Inch LED Recessed Lighting Retrofit Square User Guide

▶ DESIGN – LED DOWNLIGHT RETROFIT KIT has a classic, low-profile design with a baffle trim that allows you to have a stylish look with efficient lighting. The preinstalled TP24 and E26 connectors and spring-loaded clips
make your installation quick and easy. The acrylic lens with a 105° beam angle and CRI90+ grants you even light. It is designed to operate on 120V circuits.
▶ COLOR SELECTABLE – You can choose either a 2,700K soft white, 3,000K warm white, 3,500K neutral white, 4,000K cool white, or 5,000K daylight color temperature.
▶ DIMMING – Smooth triac dimming capabilities ranging from 10% to 100% with modern LED dimmers allow you to control the look and feel of your space.
▶ INSTALLATION – This fixture is suitable for most new construction, remodeling, and shallow recessed lighting housings. It is also Wet Locations rated, making it perfect for kitchen, bathroom or any other common areas.
▶ ADVANTAGES – With a lifespan of 50,000 hours, these fixtures are made to last decades under normal operation! ASD provides a 5-year limited warranty along with UL certification to guarantee top quality products and safety

PRODUCT SPECIFICATIONS:

INSTALLATION GUIDE

IMPORTANT SAFETY INFORMATION:
Please read all the instructions below before installation.

Make sure that the supply voltage corresponds to the rated product voltage.
The product must be installed by a qualified electrician in accordance with the National Electrical Code and corresponding local codes.
If the product is damaged, do not use it.

INSTALLATION STEPS 4” AND 6”:

Choose needed color temperature by adjusting the switch.
Turn off the main power and remove the existing trim and bulb from the can.
Use one of the options to connect the terminals.
Carefully route wires into the can and gently push the fixture up into the can until sealed.

WARNING

RISK OF PERSONAL INJURY – READ and follow all WARNINGS and installation instructions. Keep or give to the owner for future reference.

Risk of cuts: Wear gloves to prevent cuts or abrasions when removing from carton, handling, installing, and maintaining this product.

Risk of electric shock: This product must be installed in accordance with then applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

Risk of Fire: Minimum 194°F supply conductors. Consult a qualified electrician to ensure correct branch circuit conductor.
ASD® assumes no responsibility for claims arising out of improper or careless Installation or handling of this product.

ELECTRICAL SCHEMATIC DIAGRAM:

INSTALLATION STEPS 5″ AND 6” ROUND:

Choose needed color temperature by adjusting the switch.
Turn off the main power and remove the existing trim and bulb from the Can.
Use one of the options to connect the terminals.
Squeeze the two sets of spring clip arms up toward each other. Route wires into the Can and hook both springs into the arm hook on the inside of Can. Release springs and gently push the fixture up into the Can until sealed.

ORDERING INFORMATION

For most up-to-date spec sheets please refer to asd-lighting.com

ASD LIGHTING CORP

E-mail: orders@asd-lighting.com

Web site: www.asd-lighting.com