Newell HL1000COB USB-C Headlamp User Manual

Headlamp HL1000COB USB-C
OPERATING MANUAL

SAFETY INSTRUCTIONS

Before using the product, please read the following instruction manual carefully and keep it for future reference. When transferring the product to a third party, it is advisable to include the instructions.

1. The lamp is a precision device. Do not drop, hit, crush or expose to any shock.
2.  Do not use near flammable materials and solvents.
3. Store the product in dry and ventilated place.
4.  Do not insert metal parts into the lamp. Do not touch the electrical parts with conductive materials.
5.  The lamp can operate in a temperature range of 0C-40C.
6. Product will generate heat while working, please be cautious with that to avoid any possible harm.
7. 00 not stare directly at the LED panel that is turned on.
8. Do not use the LED outside in direct sunlight for a long time.
9. For use by adults.
10.  Do not disassemble. Disassembling the unit will void the warranty.
    If there are problems with the lamp, bring it to an authorized service center.

Maintenance
Use a dry and soft cloth to clean the unit. A little neutral detergent on the cloth to remove stubborn dirt. Do not use strong detergents such as thinner, benzine or alcohol as they may damage the protective coatings.

Important!

• When the device shows low power, please recharge the lamp.
• When not in use for a long time, please recharge it every 3 months to ensure the durability of the battery.
• Please cover the rubber piece of USB ports well after recharging or discharging to avoid foreign matter.

CONSTRUCTION

1. LED
2. On/Off switch
3. Battery slot
4. USB-C charging port
5.  Charge level indicator light
6.  Headband

USAGE

The LED Lamp can be used in two ways:

1. On the head using the headband
   

2. On the helmet using dedicated connector

Note:
To place the light on the helmet, stick the dedicated connector using 3M tape and wait 48 hours after sticking. To mount the light on the connector, remove the headband from the plastic holder.

CHARGING / DISCHARGING

Charging

To charge the light, connect the charging cable to the USB-C socket.
Charging of the device will be indicated by a red LED.
Changing the colour of the LED from red to green indicates that charging is complete.
Discharging

When the charge level falls below 5%, the light will signal by 3 flashes. The light will then signal the critical charge level 4 times at 30 second intervals before switching off.

BATTERY REPLACEMENT

To replace the battery, unscrew the socket marked “open” according to the direction placed, remove the battery, place a new battery with the same parameters (18650 3.6V) according to the polarity, and then screw the socket on.

SPECIFICATION

(Ii-ion 18650 battery)
Charging| USB-C 5V 1A
Charging Time| 3-4h
Weight| 127g (include battery)
Waterproof class| IP54
Drop resistance| 2m
LED| COB Led

SET CONTENTS

• The manufacturer reserves the right to change the information contained in this manual without prior notice.

WASTE MANAGEMENT

The crossed-out trashcan symbol means that waste electrical and electronic, batteries and packagings must not be placed with other household waste.They must be handed over to a separate waste collection system.

WARRANTY

Newell products are covered by a 40-month manufacturer’s warranty.

Made in China, In China hergestellt, Hecho en China,
Fabbricato in Cina, Fabriqu~ en Chine, Vyrobeno v Cine,
Wyprodukowano w Chinach, CpenaHo s Krae

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>