REINA A-LGC060B Brenta Panel Radiator Installation Guide
- June 16, 2024
- Reina
Table of Contents
REINA A-LGC060B Brenta Panel Radiator Installation Guide
Package Content
-
CLIPS X 2PCS
-
WALL ANCHORS 4 PCS
-
FIXING X SCREWS 4 PCS
-
CAP X 2 PCS
-
END PLUG X 1 PCS
-
AIR VENT X 1 PCS
Installation Instruction
The product was sent you as the rubber was weared on the product. Make sure
and control that the rubber is connected to product after montage process
| NAMES | HEIGHT | A | B | C | DA | DM | DA |
|---|---|---|---|---|---|---|---|
| BRENTA | 1800 | 410 | 1745 | 165 | 21 | 36 | 65 |
| BRENTA | 1800 | 614 | 1745 | 125 | 21 | 36 | 65 |
GENERAL RECOMMENDATION
- Before fitting the radiator it is necessary to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.
- When the system water pH is outside the 8,5 -5,5 range and/or when the dissolved is above 0,1mg/liter, it is always needed to protect the heating system components (the radiator is one of these) with a proper chemical treatment compatible with all parts in contact with water (silicon rubber too).
- In order to fit the radiator to the wall, it is necessary to choose the proper fixings for the wall material.
- If the system water exceeds 50C, please install a warning mark near the radiator to avoid any accidental scalding.
- Clean the radiator surface only with a soft cloth to avoid scratching the finish and do not use chemical against during cleaning operations. It is prohibited to climb on the radiator.
- Maximum working temperature *95C, maximum working pressure 4 bar.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>