SEALEY SPB10W 10000mAh Lithium DC Power Pack 10W User Guide
- June 4, 2024
- SEALEY
Table of Contents
SEALEY SPB10W 10000mAh Lithium DC Power Pack 10W
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
IMPPORRTATANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR
THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE USE.
- Refer to instructions
- Keep in a dry area to protect from rain
- Electrical shock hazard
- Warning: explosive material
SAFETY
ELECTRICAL SAFETY FOR USE OF POWER PACK
-
WARNING! It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimized by the installation of appropriate safety devices. -
You must also read and understand the following instructions concerning electrical safety. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified electrician, using a Portable Appliance Tester (PAT).
-
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
You must ensure that you: -
Inspect the Power Pack, charge cables, and connectors for wear and damage to ensure items are safe before use. If worn or damaged DO NOT use it.
-
Uncoil used cables between Power Pack and devices when in use.
-
DO NOT pull the Power Pack from any sockets by the lead used.
-
DO NOT try to take the Power Pack apart.
-
DO NOT get the Power Pack wet, or use it in wet, damp conditions (for indoor use only).
-
WARNING! Modern vehicles contain extensive electronic systems.
Check with the vehicle manufacturer, for any specific instructions regarding the use of this type of equipment on each vehicle. No liability will be accepted for damage/injury, where this product is not used in accordance with all instructions.
BATTERY SAFETY
- Recycle or dispose of used batteries as stipulated by local regulations.
- Ensure the internal battery is fully charged before initial use.
- WARNING! To reduce the risk of burns or fi re:
- DO NOT attempt to open, disassemble, modify or service the battery pack.
- DO NOT crush, puncture, short external contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 60°C (140°F).
- DO NOT move/handle/use the Power Pack when it is being charged.
- DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.
GENERAL SAFETY INSTRUCTIONS
- Familiarise yourself with the application and limitations of the Power Pack as well as the potential hazards.
- Keep children and unauthorized persons away from the working area.
- When not in use, store carefully in a safe, dry, childproof location.
- Use the cable provided with this unit only.
- DO NOT short circuit this unit and keep it away from metal objects such as coins, keys, jewelry, etc.
- DO NOT pull the cables or clamps from any connections.
- DO NOT use the unit outdoors, or in damp, or wet locations, and DO NOT operate within the vicinity of flammable liquids or gases.
- DO NOT use it for a task for which it is not designed.
- DO NOT modify or disassemble the Power Pack.
- DO NOT drop the unit. If the unit receives a sharp blow or is otherwise damaged in any way have it checked by a qualified technician.
NOTE:
This appliance can be used by children aged 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the
use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
INTRODUCTION
Powered by lithium-ion technology. Easily fi ts in a glove box or backpack, weighing less than 0.3kg. Fitted with a 10,000mAh battery. This unit can supply multiple full charges to both smartphones and tablets (over three charges to iPhone8 and more than two full Galaxy S8 charges). Supplied with Micro USB charging cable.
SPECIFICATION
- Model No: ……………………………………………………….SPB10W
- Dimensions (W x D x H) …………………………..96 x 63 x 25mm
- Input: ………………….. 1 x Micro USB: 1 x Type-C (both 5V 2A)
- Output: …………………………………………………………. DC 5V 2A
- Capacity: …………………………………………..10,000mAh Battery
- Accessories: ……………………………………….Micro USB Cable
- Charge time: …………………………………………………….. 6 hours
OPERATION
CHARGING THE POWER PACK
- Insert the Micro USB (fi g 1 – 4) or Type-C (fig 1 – 3) cable into the power pack’s relevant input port.
- Insert the other end into either a USB wall charger, a car accessory charger, or the USB port on a computer (none supplied).
- While charging, the LED indicator (fi g 1 – 5) will display the battery charge level. One flashing LED light indicates 0-25% charge, and four LED lights ON, indicate the power pack is fully charged.
- When the power pack is fully charged disconnect from the charging source. DO NOT leave the power pack on charge for long periods.
POWER BUTTON FUNCTION
- Press the power button (fi g 1 – 1) once, for the LED lights to display the battery charge level.
USING THE POWER PACK
- Insert the USB cable (fi g 1 – 6) into the USB output (figs 1 – 2) on the battery pack.
- Insert the micro USB connection on the USB cable (figs 1 – 6) into the digital device to be charged.
- When the digital device is fully charged, disconnect it from the power pack.
MAINTENANCE
- After usage recharges the power pack.
- After charging or usage removes all cables or connections.
- Use a clean, dry cloth to wipe down the battery pack after use.
- When not in use store the power pack in its original packaging in a safe, clean, dry environment.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories, and packaging should be sorted, taken to a recycling center, and
disposed of in a manner that is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries
(as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd’s Batteries Producer
Registration Number (BPRN) is BPRN00705.
Note:
It is our policy to continually improve products and as such, we reserve the
right to alter data, specifications, and component parts without prior notice.
Important:
No Liability is accepted for the incorrect use of this product.
Warranty
Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR. 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk. © Jack Sealey Limited Original Language Version SPB10W Issue 1 09/06/21.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>