Sdion HC-WC02 Magnetic Wireless Charging Phone Mount Instruction Manual

June 16, 2024
Sdion

HC-WC02 Magnetic Wireless Charging Phone Mount

MANUAL

Magnetic Wireless Charging Phone Mount

HC-WC02

Parts

  1. Antistip Silicon Pad
  2. Coil Induction Area
  3. Ball Socket
  4. Bal-Nut
  5. Airvent Hook
  6. Cable

Installation

Instruction

Plug-in the cable, then place the center of the mobile phone in
alignment with the center of the magnetic phone mount to start a
tutomatic wireless charging immediately

The magnetic phone mount can be detached from the installation
part attached to the vehicle, When the phone mount is removed
itcould be used as a destop ring phone holder, Keep the
magnetic phone mount connected to the cable for wireless
charging feature

Parameters

Model:HC-WC02
Input:5V/2A 9V/2A
Output:15W(Max)

FCC Statement

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.

  • Connect the equipment into an outlet on a circuit different from
    that to which the receiver is connected.

  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modications to this device not explicitly
approved by manufacturer could void your authority to operate
this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set
forth for an uncontrolled
environment. The FCC certification of this device refers to RF
exposure testing performed in
typical operating conditions, where a person is no closer than 20
centimeters from the device
surface at all times, except for non-repetitive patterns with
transient time intervals in the
order of a second. Only in the stated conditions, the device is
shown to fully comply with the FCC RF Exposure requirements of
KDB 447498.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals