Sdion HC-WC02 Magnetic Wireless Charging Car Mount User Manual
- June 16, 2024
- Sdion
Table of Contents
HC-WC02 Magnetic Wireless Charging Car Mount
User Manual
HC-WC02 Magnetic Wireless Charging Car Mount
Magnetic Wireless Charging Phone Mount
HC -WC02
Parts
- Antilipo Second Pad
- Coil Induction Area
- Ball Socket
- Banet
- Ardent Hook
- cable
Installation
- Insert the ball-nut through the ball socket of the ardent hook component part
- Attach the ball and socket joint together
- Tum locking knob anti-clockwise to tighten and attach the joint components
- Gently place the desktop ring phone holder over the assembled component parts and it will magnetically attach to each other
- Insert the hook into the vehicle ardent and hook it onto the grille
- Turn knob clockwise to tighten hook and lock onto the grille, fix support
Instructions
Plugin the cable, then pace the center of the mobile phone in alignment with the center of the magnetic phone mount o start aromatic wireless charging immediately.
The magnetic phone mount can be detached from the installation part attached
to the vehicle. When the phone mount is removed it could be used as a desktop
ring phone holder. Keep the magnetic phone mount connected to the cable for
wireless charging feature
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or medications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The FCC certification of this device refers to RF
exposure testing performed in typical operating conditions, where a person is
no closer than 20 centimeters from the device surface at all times, except
for non-repetitive patterns with transient time intervals in the order of a
second. Only in the stated conditions, the device is shown to fully comply
with the FCC RF Exposure requirements of KDB 447498.
Parameters
Model:HC-WC02
Input:5V/2A 9VI2A
Output:15W(Max)
Made in China
Documents / Resources
|
Sdion HC-WC02 Magnetic Wireless Charging Car
Mount
[pdf] User Manual
HC-WC02 Magnetic Wireless Charging Car Mount, HC-WC02, Magnetic Wireless
Charging Car Mount, Wireless Charging Car Mount, Charging Car Mount, Car Mount
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>