soundcore H30i Wireless On Ear Headphones User Guide
- June 16, 2024
- Soundcore
Table of Contents
soundcore H30i
Quick Start Guide
Model: A3012
51005004255 V2
WEARING
CHARGING
POWERING ON & PAIRING
BUTTON CONTROLS
For FAQs and more support information, please visit:
https://rainbowbridge.anker.com/qrscan?key=soundcore_A3012_UG
Scan to View User Guide
https://rainbowbridge.anker.com/qrscan?key=soundcore_A3012_UG
FCC ID: 2AOKB-A3012
IC: 23451-A3012
Input: 5V 0.8A
18-month limited warranty
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc.
and any use of such marks by Anker Innovations Limited is under license.Other
trademarks and trade names are those of their respective owners.
Important Safety Instructions
- Do not disassemble.
- Keep out of the reach of children. The product contains small parts which may be a choking hazard.
- The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Do not use the product in environments with too high or too low temperatures, and never expose the product to strong sunshine or very wet environments.
- Ensure there is no liquid, sweat or water on the charging port when charging.
- Refer to your user manual for your earphones’ waterproof level and follow the corresponding instructions.
￮ For IPX4: Do not expose earphones to dripping or splashing water.
￮ For IPX4, IPX5, and IPX6: Do not submerge earphones in water.
Hearing Safety
- To avoid hearing damage, do not listen for extended periods at high volume.
- Do not turn the volume so high that you’re unable to hear your surroundings.
- Do not use earphones while driving.
- You should use caution or temporarily discontinue use in potentially hazardous situations.
The product generates stronger permanent magnetic fields that could cause interference with cardiac pacemakers, implanted defibrillators (ICDs) and other implants. Always maintain a distance of at least 3.94″/10 cm between the product component containing the magnet (earbuds and charging case) and the cardiac pacemaker, implanted defibrillator, or other implant.
Notice
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: https://www.soundcore.com.
Maximum output power: 9.0dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)
This symbol means the product must not be discarded as household waste, and
should be delivered to an appropriate collection facility for recycling.
Follow local rules and never dispose of the product and rechargeable batteries
with normal household waste. Correct disposal of old products and
rechargeable batteries helps prevent negative consequences for the environment
and human health.
This symbol indicates “separate collection” for all batteries and
accumulators. Danger of explosion if battery is incorrectly replaced. To
reduce risk of fire, explosion or leakage of flammable liquid/gas, don’t
disassemble, crush, puncture, short external contacts, expose to temperature
above 60°C (140°F), sunshine or like, expose to extremely low air pressure or
dispose of in fire or water. Replace only with specified batteries.
High or low extreme temperatures that a battery can be subjected to during use, storage or transportation:
- During use: maximum 40℃ (104°F)
- Storage: -20 – 45℃ (-4 – 113°F)
- Transportation: 5 – 35℃ (41 – 95°F)
FCC Statement
This product complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The highest SAR value reported under this standard during product
certification for use next to the head with the minimum separation distance of
0mm. This transmitter must not be collocated or operating in conjunction with
any other antenna or transmitter.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973
IC NOTICE TO CANADIAN USERS
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled
exposure limits in IC RSS-102 and had been tested in accordance with the
measurement methods and procedures specified in IEEE 1528 and IEC 62209. This
equipment should be installed and operated with minimum distance 0mm between
the radiator and your head. This device and its antenna(s) must not be co-
located or operating in conjunction with any other antenna or transmitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>