soundcore A3850R Wireless Earbuds Instructions
- October 27, 2023
- Soundcore
Table of Contents
A3850R Wireless Earbuds Instructions
Model: A3850, A3850L, A3850R, T0350
51xxxxxxxxxx V01
Important Safety Instructions
- Avoid dropping.
- Do not disassemble.
- Avoid extreme temperatures.
- Use original or certified cables.
- Do not wear the product while charging.
- Do not use any corrosive cleaner or oil to clean.
- Do not use the product outdoors during thunderstorms.
- Keep out of the reach of children. The product contains small parts which may be a choking hazard.
- The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Do not use the product in environments with too high or too low temperatures, and never expose the product to strong sunshine or very wet environments.
- Ensure there is no liquid, sweat or water on the charging port when charging.
- Refer to your user manual for your earphones’ waterproof level and follow the corresponding instructions.
- For IPX4: Do not expose earphones to dripping or splashing water.
- For IPX4, IPX5, and IPX6: Do not submerge earphones in water.
Hearing Safety
- To avoid hearing damage, do not listen for extended periods at high volume.
- Do not turn the volume so high that you’re unable to hear your surroundings.
- Do not use earphones while driving.
- You should use caution or temporarily discontinue use in potentially hazardous situations.
The product generates stronger permanent magnetic fields that could cause interference with cardiac pacemakers, implanted defibrillators (ICDs) and other implants. Always maintain a distance of at least 3.94 /10 cm between the product component containing the magnet (earbuds and charging case) and the cardiac pacemaker, implanted defibrillator, or other implant.
Notice
**** This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available
at the following internet address: https://www.soundcore.com.
This product complies with the radio interference requirements of the United
Kingdom.
Declaration of Conformity Hereby, Anker Innovations Limited declares that this
product is in compliance with Radio Equipment Regulations 2017. The full text
of the UK declaration of conformity is available at the following internet
address: https://www.soundcore.com.
Maximum output power: 9.0dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)
This symbol means the product must not be discarded as household waste, and
should be delivered to an appropriate collection facility for recycling.
Follow local rules and never dispose of the product and rechargeable batteries
with normal household waste. Correct disposal of old products and rechargeable
batteries helps prevent negative consequences for the environment and human
health.
This symbol indicates “separate collection” for all batteries and
accumulators. Danger of explosion if battery is incorrectly replaced. To
reduce risk of fire, explosion or leakage of flammable liquid/gas, don’t
disassemble, crush, puncture, short external contacts, expose to temperature
above 60°C (140°F), sunshine or like, expose to extremely low air pressure or
dispose of in fire or water. Replace only with specified batteries.
High or low extreme temperatures that a battery can be subjected to during use, storage or transportation:
- During use: maximum 40°C (104°F)
- Storage: -20 – 45°C (-4 – 113°F)
- Transportation: 5 – 35°C (41 – 95°F)
FCC Statement
This product complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
FCC RF Exposure requirements for Headphone: The highest SAR value reported
under this standard during product certification for use next to the head with
the minimum separation distance of 0mm. This transmitter must not be
collocated or operating in conjunction with any other antenna or transmitter.
FCC RF Exposure requirements for Dongle: The highest SAR value reported under
this standard during product certification for use next to the body with the
minimum separation distance of 0mm. This transmitter must not be collocated or
operating in conjunction with any other antenna or transmitter.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973
IC NOTICE TO CANADIAN USERS
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>