LITETRONICS ALATM Area Light Trunnion Mount Instruction Manual
- June 16, 2024
- Litetronics
Table of Contents
LITETRONICS ALATM Area Light Trunnion Mount
Product Information
Specifications:
- Model: Area Light Trunnion Mount (ALATM)
- Mount Size: M8 20mm (x4), M8 16mm (x2), M5 * 12mm (x2)
- Included Accessories: Spring Washer M8 (x6), Flat Washer M8 (x6), Ground Washer M8 (x2), Expansion Bolts (x2)
Product Usage Instructions
Safety Instructions and Warnings:
- Before starting the installation, carefully remove all parts from the packaging and inspect the product for any defects.
- Always turn off the power supply from the main circuit breaker before proceeding with the installation.
Required Tools:
- Allen Wrench
FAQ
-
Q: Where can I find updated instructions for the product?
A: To check for an updated version of these instructions, please visit our website at www.litetronics.com. -
Q: What should I do if I have questions about specific product details?
A: If you have any questions regarding specific product details, please contact our customer service at 800-860-3392 or via email at customerservice@litetronics.com.
SAFETY INSTRUCTIONS AND WARNINGS
- When using electrical equipment, basic safety precautions should always be observed.
- This product must be installed by the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Installation should only be conducted by a qualified electrician by NEC and any relevant local building codes.
- Be certain electrical power is OFF before and during installation and maintenance.
- To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or sharp objects.
WHAT COMES IN THE BOX
- Trunnion Mount
- M8 * 20mm (x4)
- M8 * 16mm (x2)
- M5 * 12mm (x2)
- Spring Washer M8 (x6)
- Flat Washer M8 (x6)
- Ground Washer M8 (x2)
- Expansion Bolts (x2)
- Installation Instructions
REQUIRED TOOLS
- Allen Wrench
INSTRUCTIONS
Before Installation, carefully remove all parts from the packaging. Inspect
product for defects due to shipping.
Always turn off the power supply from the main circuit breaker first!
- Open the mount head. (Figure 1)
- Affix the base with screws and lock on to the fixture. (Figure 2)
- Pass the wires through the trunnion mount head. (Figure 3)
- Finish the wire connection accordingly (refer to area light installation instructions for the wiring diagram).
- Align the fixture to the required angle. Tighten the M5 screw and M8 screw after the angle is confirmed. (Figure 4)
- Turn the power back on.
Note: The adjustable angle is 0~+/-90 °. (Figure 4)
Thank you for choosing
6969 W. 73rd Street
Bedford Park, IL 60638
WWW.LITETRONICS.COM
CustomerService@Litetronics.com or
1-800-860-3392
The information and product specifications contained in these instructions are based upon data believed to be accurate at the time of printing. This information is subject to change without notice and without incurring liability. If you have questions regarding specific product details, please contact us at 800-860-3392 or via email at customerservice@litetronics.com. To check for an updated version of these instructions, please visit www.litetronics.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>