PAC RP5-GM52-HAR No Reverse Camera Image Instruction Manual
- June 16, 2024
- PAC
Table of Contents
PAC RP5-GM52-HAR No Reverse Camera Image Instruction Manual
Overview
Symptom : No reverse camera image is displayed on the aftermarket radio
when the vehicle is in reverse.
Cause : In some vehicles, the reverse camera image goes into the radio
display prior to going into the radio.
Solution : Wire the input and output camera wires together at the radio
display harness.
Steps to Hard Wire
-
Locate pins 5, 6, 7 and 8 at the Gray 20 pin harness on the back of the radio display (see Fig.1).
-
Cut the wires going to pins 5, 6, 7 and 8, near the connector, but leave enough length so that the wires can be
reconnected if the factory radio is reinstalled. -
The loose cut wires coming from the connector will not be used. The loose cut wires that continue into the
harness will need to be connected as follows (see Fig.2):
Connect Pin 5 to Pin 7.
Connect Pin 6 to Pin 8. -
Connect the Reverse Camera output connector from the RP5-GM52-HAR to the Reverse Camera input on the aftermarket radio.
Fig.1
Fig.2
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Rev: 1
Date: 111418
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>