vtech Turbo Edge Riders Rally Track Set Instruction Manual

: June 16, 2024
: vtech

Table of Contents

INTRODUCTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

vtech Turbo Edge Riders Rally Track Set Instruction Manual

INTRODUCTION

Rev up your creative engine with two motorized, daredevil off-road vehicles. Zoom along the edge of included tracks and through exciting stunts. Upcycle materials from around the house to expand your race track for even more gravity-defying riding.

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.

NOTE
Please save this manual as it contains important information.

WARNING:

CHOKING HAZARD—Small parts.
Not for children under 3 yrs.

IMPORTANT NOTES

1. For your child’s safety, do not put the vehicles on your clothing, body or hair.
2. If the car is not running on the cardboard smoothly or falls off the track, please try the following:
2.1 Adjust the curvature of the cardboard to prevent sharp angles.
2.2 Adjust the position of the stands to allow the top edges of the tracks to align.
2.3 Trim away the damaged part of the cardboard and connect the cardboard firmly again.
2.4 Replace the cardboard by tracing and cutting out a new track piece. For best results, use cardboard between 6mm and 8mm in thickness.
3. Keep the cardboard track pieces in dry place.

ASSEMBLY INSTRUCTIONS

With the Turbo Edge Riders TM Rally Track Set , safety comes first.
Adult assembly required. For your child’s safety, do not let them play with this toy until the initial assembly steps are completed. See the color manual for initial assembly instructions.

GETTING STARTED

Battery Removal and Installation

Make sure the unit is turned Off.
Find the battery cover located on the wheels on each side, use a screwdriver to loosen the screw and then open the battery cover.
Remove the old battery by pulling up on one end of the battery.
Install 1 new AA (LR6/AM-3) battery following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
Replace the battery cover and tighten the screw to secure.
Do the same installation on the other side of the vehicle.

WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

Insert batteries with the correct polarity (+ and -).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Do not short-circuit the supply terminals.
Remove batteries during long periods of non-use.
Remove exhausted batteries from the toy.
Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES:

Remove rechargeable batteries (if removable) from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision.
Do not charge non-rechargeable batteries.

CARE & MAINTENANCE

Keep the vehicles clean by wiping them with a slightly damp cloth.
Keep the vehicle out of direct sunlight and away from any direct heat sources.
Remove the batteries if the vehicle will not be in use for an extended period of time.
Do not drop the vehicle on hard surfaces and do not expose the vehicle to moisture or water.

TROUBLESHOOTING

If for some reason the vehicle stops working or malfunctions, please follow these steps:

Turn the vehicle Off.
Interrupt the power supply by removing both batteries.
Let the vehicle stand for a few minutes, then put back the batteries.
Turn the vehicle On. The vehicle should now be ready to use again.
If the vehicle still does not work, install a new set of batteries.

IMPORTANT NOTE
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or visit our website vtechkids.com and fill out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

vtechkids.com

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty