DeerTalk FL01 Christmas LED Floor Lamp User Manual
- June 16, 2024
- DeerTalk
Table of Contents
DeerTalk FL01 Christmas LED Floor Lamp
DIMENSIONS
unit: inch
INSTALLATION
-
Splicing sequence of aluminum rod
-
Splicing and assembling three aluminum rods
-
Assemble the aluminum rod onto the base and lock it with two M3 countersunk screws
-
Assemble the lamp pole plug and lock it with two M3 round head screws
-
Assembling the neon light strip section
a. Clip the top light strip to the aluminum pole;
b. Next, insert the plug of the bottom neon light strip; c. Then clip the bottom neon light strip onto the aluminum pole; d. Finally, clip the rest of the neon light into the aluminum pole. -
The entire lamp assembly is completed
REMOTE BUTTON
TOUCH BUTTON FUNCTION
- Click once : Mode Switching, the order of mode switching is: 1. Leisure-2. Colorful -3. Dazzling -4. Blue Sky -5. Birthday -6. Fantasy -7. Entertainment -8. Warm Light -9. Off
- Click twice : OFF
- Long press : Long press for 5s to access the network
NOTICE
- The product is only suitable for indoor use, avoid long time work in humid environment;
- Do not soak the product in water or other liquids;
- When installing, the screws need to be locked firmly and not loose;
- Do not install the product in a high temperature environment;
- The adapter needs to be connected in place, and there must be no looseness or poor contact;
WiFi CONNECTED & APP SETTINGS
- Download “Tuya Smart” or “Smart Life” APP from Google play or App Store, or scan the QR code below.
|
| 
|
---|---|---|---
2. Register and log in
-
Ensure that the phone is connected to 2.4GHz WiFi network, and enable 4G mobile data, Bluetooth and GPS. When the device needs to connect to the app, long press the touch button of the base for 5 seconds. When the red light flashes, the user can open the app to access the network. If the device fails to access the network for 3 minutes, the device automatically enters the steady-on mode. If the device needs to access the network again, long press the button for 5 seconds. When red light flashes, the network can be configured.
-
Automatically search for devices (recommended first).When the device is connected to the network, the APP home page interface will automatically pop up (Find the devices to be added).Click Add or click + icon on the upper right corner of the APP home page, to choose Add Device and enter the Add interface for selecting the device to be added.
-
Select a network and click Next
-
The device is now in the linking state. It means added successfully when appear “√” and the red light stops flashing.
-
7 Manually add a device. The device must be in the connected state. Click Add in the upper right corner of the home page to select Add Device. On the Add Device page, choose Lighting – Light Source (BLE+ Wi-Fi).
-
Continue to configure the network and confirm that the light flashes quickly or breathes.
-
Choose whether light flashes or breathes quickly based on the flashing status of the light.
-
Select 2.4 GHz Wi-Fi network and enter the password, and then click Next.
-
Successfully added, the light stops flashing, and the app supports 2.4GHz wireless WiFi network/4G data network/Bluetooth wireless control. When using Bluetooth control, the router needs to be disconnected for about 3 minutes before connecting.
-
Light control interface.
-
Scene interface.
-
Music mode and timing function.
-
Night light switch.
-
Check the third-party voice devices supported by the device by clicking the writing icon in the upper right corner.
-
The device supports Alexa and Google Assistant.
-
APP supports Share Device and Create Group functions.
Customer Support
