DeerTalk RGBWIC Christmas LED Floor Lamp Instruction Manual

Table of Contents

The product is a light fixture that consists of a base, light rods, and a light strip. It requires screws for installation.

Specifications

Step 1: Unpackaging
Open the packaging and locate the screws provided. There should be 13 round head screws and 3 flat head screws.
Step 2: Connecting the Light Rods
There are 6 holes for connection, but only 4 of them require screws. Refer to the picture above to identify the correct holes. Use the round head screws to connect the light rods to the designated holes.
Step 3: Second Connection
Proceed to the second connection. This connection also requires 4 screws. Use the round head screws to secure the connection.
Step 4: Connecting the Base
The connector labeled “Down” should be connected to the base. There are 3 holes in total. The center hole does not require any screws, while the other 2 holes require round head screws. Refer to the picture above for guidance.
After securing the connector, use 2 flat head screws to attach the base.
Step 5: Installing the Light Strip
Once the base is securely attached, you can proceed to install the light strip according to the manufacturer’s instructions.

FAQ (Frequently Asked Questions)

Q: How many screws are included in the packaging?
A: There are 13 round head screws for connecting the light rods and 3 flat head screws for connecting the base.
Q: How many holes require screws for the first connection?
A: Out of the 6 holes available, only 4 of them require screws. Please refer to the picture provided for the correct hole placement.
Q: Which connector connects to the base?
A: The connector labeled “Down” connects to the base. It requires 2 round head screws for the side holes and no screws for the center hole.

There are 2 screws in the packaging
- Round head screw : 13 PCS (for connecting light rods)
- Flat headed screw : 3 PCS (for connecting the base)
There are 6 holes in connection, but only 4 of them are installed with screws, refer to the picture above.(Use round head screws)
The second connection is also installed with 4 screws.(Use round head screws)
The connector labeled “Down” connects to the base. There are 3 holes in total, the center hole requires no screws and the other 2 holes require round head screws. Please refer to the picture above.
- Then, the base requires 2 flat head screws.
- Next you can install the light strip.