Steelite AZGU300A Portable Solar Generator Power Station User Manual

June 1, 2024
steelite

Steelite AZGU300A Portable Solar Generator Power Station

Steelite AZGU300A Portable Solar Generator Power
Station

ATTENTION:
AC output voltage and frequency will be different depending on different countries or areas. Please refer to the actual product before using.

Thanks for purchasing our portable solar generator power station. Please read this manual carefully before use and keep it for review.
This manual helps you to operate this device correctly. But it is not the introduction of the software and hardware configuration. To know the configuration of the product, please refer to the related contract or consult with your distributor. The images in this manual are for reference only.
Thank you!

Product Description

Product Description
Product Description

Specifications

Model AZGU300A
Battery Capacity 14.8V 20000mAh 296Wh
Rated Power 300W, Peak 600W
Battery Type High Quality Lithium Ion Batteries
Charge Input CC/CV 19V/3A
AC Output 4*110V 60Hz
USB Output 2*5V/2.4A
QC 3.0 Output 5V/3A, 9V/2A, 12V/1.5A
DC Output 2*12V/8A Max
Type-C Output PD 45W: 5V/3A, 9V/3A, 12V/3A, 15V/3A
LED Flashlight 9W
Solar Charge Input 18V~30V 4A Max
Output Waveform Pure Sine Wave
Gross Weight About 3.8KG
Product Size L212W160H185 mm
Operation Temperature -10°C(14°F)~60°C(140°F)
Protection Circuit Short Circuit Protection

Over Current Protection
Over Power Protection
Over Discharge Protection
Over Charge Protection
Over Temperature Protection
Package Included| 1 x Portable Power Station
1 x AC Adaptor
1 x Power Cable
1 x Car Charger
1 x User Manual

LED Display

LED Display

Battery Level Indicator
Shows the percentage of the power. If it shows 0%, please charge it immediately

Fan Indicator
The fan automatically turns on when the battery temperature gets high.

Current Input
Shows the current input power in

Current Output
Shows the current output power in watts.

Temperature Status Indicator
Green light: Under normal temperature
Yellow light: Cooling fan starts working when the battery temperature is over 50℃
Red light: Over-temperature warning indicates that the temperature of the product is too high. Please cool down before using it again.

Function Failures Warning
When there is short-circuit, low voltage, or exceeding maximum current/power limit, the Function Failure sign will show on the display, and the corresponding outlet indicator will flash simultaneously for 60 seconds. At the same time, it automatically stops running immediately. Please remove the overloaded devices and then restart the power station to resume work.

How To Use Your Portable Power Station

  1. Power ON/OFF
    Power ON/OFF button is the master switch. Press power ON/OFF button for
    seconds to activate the AC/DC/USB button. It will switch off within 30 seconds automatically when there is no load.
    How To Use Your Portable Power Station

  2. DC Output ON/OFF
    Press DC button once to activate the DC/USB/TYPE-C output, and once more to power OFF. It will switch off within 1 hour automatically when there is no load.
    How To Use Your Portable Power Station

  3. AC Output ON/OFF
    Press AC ON/OFF button for 2 seconds to activate the AC button. It will switch off within 3 hours automatically when there is no load.
    How To Use Your Portable Power Station

  4. LED Light
    Press LED ON/OFF button for 2 seconds to activate the flashlight. There are 4 modes for the LED: high light, low light, SOS and strobe.
    How To Use Your Portable Power Station

How To Charge The Portable Power Station

Charging by AC adaptor

Please connect our original adaptor to the household AC socket, connect the DC plug of standard charging adaptor with the DC input interface of this product, and you’ II know that the unit is charging when the battery icon lights up with the light twinkling at the same time. When the product is fully charged, the battery icon will fully light. After the power station is fully charged, please remove the charger in time.
How To Charge The Portable Power Station

Charging by Solar Panel

  • Place your solar panel where it will get as much direct sunlight as possible.
  • Plug the output of the solar panel(DC 5.5*2.1mm) into the input of the unit to start charging. Connect with the DC input interface of this product. You’ll know that the unit is charging when the battery icon lights up. When the product is full of power, the battery icon will fully light.

Frequently Asked Questions

  1. Can the product be carried on the plane?
    No. According to the international air transport standards, the lithium battery brought on board the plane should not exceed 100Wh, and the built-in lithium battery of this product is 296Wh.

  2. Why the device power sometimes is not available within 300W?
    a. The power station’s power is less than 20%, and it needs to be charged in time.
    b. The instantaneous starting power of your equipment is larger than the peak power of the power station, or the nominal power of the equipment is larger than the actual power of our power station. It is recommended to choose our larger power products.

  3. Why is there a sound when the product works?
    The power station has a built-in cooling fan system. The built-in fan can better help the product to dissipate heat to achieve a high conversion rate. It is common to have a slight noise during use.

  4. Is the charger(adaptor) heating up normally while the product is charging?
    It is normal for the charger to heat up during charging. The standard charger conforms to

Product Application Skills

  1. This product is built in high quality original lithium ion battery. It has no memory effect but high-capacity, and it is durable. However, we still recommend you to apply in the range of 10 ℃ ~30 ℃, so as to obtain the optimal charging capacity.
  2. When charging, in order to avoid interference, please stay away from TV, radio and other equipment.
  3. If the device has not been used for a long time, please disconnect the cable and store.
  4. Some portable devices may need to be set in charge mode to charge. Refer to the corresponding equipment use manual for more information.
  5. After starting, if there is no any output, its display will automatically shut down within 20 seconds, so as to achieve better energy-saving effect.
  6. Please deal with scrap products in accordance with the regulations, do not treat the built-in battery as a household garbage, so as not to cause explosion and pollution.
  7. The product is only used for emergency power station which can not replace the standard DC or AC power of household appliances or digital products.
  8. The device has an internal, non-removable and rechargeable battery. Do not attempt to remove the battery, as you may damage the device.

To preserve lifespan recharge every 3 months
Icon Use original or certified cables
Don’t expose to liquids
Don’t disassemble
Avoid dropping
Avoid extreme temperatures

Email: steelite@nbdeli.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals