COMOMY SKUD44950 80 Extra Wide Baby Gate User Guide
- June 16, 2024
- COMOMY
Table of Contents
COMOMY SKUD44950 80 Extra Wide Baby Gate
WARNING
- Keep small parts out of the reach of children and pets! This safety gate must not be fitted across windows or other similar openings.
- Do not cut off the belt before installation is completed!
- Adult assembly is required. Exercise care when unpacking and assembling product.
- To prevent serious injury, make sure the gate is securely installed.
- Improper installation could result in the gate becoming unstable or dislodged from the doorway. Always make sure the extension is securely attached to the gate before using.
- Always install and use all required parts as directed.
- Use only when the locking/latching mechanism is securely engage.
- The position of the safety barrier in relation to the stairs may have an adverse effect on your child’s safety. Never use at the top of stairs without hardware mounting.
- Intended for use with children aged 6 to 24 months.
- Never use to keep children away from pools.
- Stop using when a child can climb over or dislodge the gate.
- Always close and lock the gate behind you.
- This product will not necessarily prevent all accidents. Never leave children unattended.
- Please be aware of weak or drywall and paint, we do not recommend installation on these surfaces to avoid property damage and maintain safety.
PRODUCT & PARTS
- A Gate Door x 1
- B Extension x 2
- C Dry Wall Anchor x 4
- D Screw x4
- E Fixed Head x 4
WARNING: This package contains small parts and sharp points in an unassembled state. Keep out of reach of children. Adult assembly required.
INSTALLATION GUIDE
STEP 1 UNLOCK THE KNOB
STEP 2 INSERT THE FIX HEAD
STEP 3 APPLICATION SCENARIOS
Measure the installation width where you install the gate, then choose the below 5 methods to install. Please follow the below 5 method to install.(Notice: installation width have to under 80″)
3-1
Installation Method
Rotate the both side panel until the width fits the installation place.
Then install the gate on the wall like picture shows.
STEP 4 WALL FIXING
4-1
4-2-1
-
Use 2mm rotary shaft when install on the wood wall, then fix with screw.
4-2-2 -
Use 5mm rotary shaft when install on the non wood wall, then insert with plastic expansion pipe, finally fix with screw.
4-3
Press the button on the bottom of the fixing head to remove the fixing head.
Insert the screw with the bolt driver.
4-4
4-5
Rotate the knob in clockwise direction to tighten the bolt. Check the knob
before each use.
4-6
Two steps to open the gate Unfold the gate panel, then insert the 4 pieces
wall fix head.
Press the button and insert the wall fix head.
- The top switch needs to be pulled back while lifting the guardrail.
- Pull up the gate until higher than the lock that on the bottom of the gate, then gate open
STEP 5 FOLD UP THE GATE
5-1
5-2
Press the button on the bottom of the fixing head to remove the gate from the
wall.
5-3
Fold up the gate like the below picture show
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>