SOLAX POWER X1 Pocket Wi-Fi Plus LAN Dongle Installation Guide

SOLAX POWER X1 Pocket Wi-Fi Plus LAN Dongle

Safety

General Notice

1. Contents may be periodically updated or revised. SolaX reserves the right to make improvements or changes in the product(s) and the program(s) described in this manual without the prior notice.
2. The installation and maintenance can only be performed by qualified personnel who:
   • Are licensed and/or satisfy state and local jurisdiction regulations;
   • Have good knowledge of this manual and other related documents.
3. Before installing the device, carefully read, fully understand and strictly follow the detailed instruction of this manual and other related regulations. SolaX shall not be liable for any consequences caused by the violation of the storage, transportation, installation, and operation regulations specified in this document and the user manual.
4. Use insulated tools when installing the device. Individual protective tools must be worn during installation, electrical connection and maintenance.
5. Please visit the website www.solaxpower.com of SolaX for more information.

Descriptions of Labels

| CE mark of conformity| | UKCA mark of conformity
---|---|---|---
| RCM mark of conformity| | FCC mark of conformity
| Do not dispose of the device together with household waste.

RF EXPOSURE WARNING!

• Install and operate the device in accordance with provided instructions.
• This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
• End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

CAUTION!

• Do not dismantle or scrap by force.
• Anti-static measures should be taken to decrease the damage of static electricity to electronic components.
• Keep away from flammable, explosive materials.
• All the product labels and nameplate on the module shall be maintained clearly visible.

CE DECLARATION OF COMFORMITY

• The product conforms to RF specifications and technical standards.
• The device complies with DOC declaration.
• The device meets the basic requirements and other relevant provisions of 2014/53/EU directive.
• The device is allowed to be used in all EU member states.

FCC RULES

This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Installation Requirements

For Wi-Fi mode, the longest connection distance between the router and the equipment should be no more than 100 meters; if there is a wall between the router and the equipment, the longest connection distance is 20 meters.

*Note:
When the Wi-Fi signal is weak, please install a Wi-Fi signal booster at the appropriate location

LAN Mode

1. Disassemble the waterproof connector into components 1, 2 , 3 and 4 ; Component 1 is not used for LAN Mode. Keep it in a safe place.

2. Mount the component 4 to the dongle back cover;
   

3. Thread the network cable through the following components (2- 3-5);

4. The male RJ45 of network cable connects to the female RJ45 on the dongle. Then connect them to the home router.; (a “Click” will be heard if it is successfully connected) Another side of the network cable connects to home router. Make sure the home router is in good condition;

5. Clockwise tighten the components (5-3-2) of Pocket WiFi+LAN in sequence;
   

* Note : Refer to “Wi-Fi Mode” for connection steps on the inverter

Monitoring Connection

• SolaXCloud App Registration
  Step 1 : Scan the QR code to download SolaXCloud App
  
  
  Step 2 : Select the language
  
  Step 3 : Create a new account and follow the tutorial on the SolaXCloud APP or the App guide at https://www.solaxcloud.com/ to complete the Wi-Fi configuration.
  
  Step 4 : Scan the QR code for more details of local mode login and the troubleshooting of Wi-Fi connection.
  

• Monitoring Website Registration
  * Note : Make sure the computer or laptop is well connected with the network.
  Step 1 : Open the browser, type www.solaxcloud.com/ into the browser;
  Step 2 : Select the language and complete the registration, login, site adding and other related operations following the “User Guide”- “Web guide”.
  

Appearance and Dimensions

Technical Data

Definition of Indicators

Contact Information

UNITED KINGDOM

Unit 10, Eastboro Fields, Hemdale Business Park, Nuneaton, CV11 6GL
+44 (0) 2476 586 998
info@solaxuk.co.uk

Warranty

Please visit our warranty website: https://www.solaxcloud.com/#/warranty or use your mobile phone to scan the QR code to complete the online warranty registration.

For more detailed warranty terms, please visit SolaX official website: www.solaxpower.com to check it.

Customer Support

SolaX Power Network Technology (Zhejiang) Co., Ltd.
Add.: No. 288, Shizhu Road, Tonglu Economic
Development Zone, Tonglu City, Zhejiang Province,
310000 P. R. CHINA
Tel.: +86 (0) 571 5626 0011
E-mail : info@solaxpower.com / service@solaxpower.com

References

• Solax Cloud System
• SolaX Power: Solar Inverter, Battery System, EV Charger
• Solax Cloud System

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>