Mills S83-0771 Guide Cabling No 2 User Guide
- June 16, 2024
- Mills
Table of Contents
Mills S83-0771 Guide Cabling No 2
Product Information
Product Code: S83-0771
Short Description: Split cabling guide for angled ducts with internal diameters of 89mm-92mm (96.5mm Duct). Used to draw the cable into the duct at an angle, the angular deviation to be no more than 30 degrees.
Description: Split cabling guide for angled ducts with internal diameters of 89mm-92mm (96.5mm Duct). Used to draw the cable into the duct at an angle, the angular deviation to be no more than 30 degrees. Ref: 126401
Product Usage Instructions
Section 1: Preparing the Duct
- Ensure that the internal diameter of the duct is within the range of 89mm-92mm.
- If necessary, clean the duct to remove any debris or obstructions.
Section 2: Installing the Cabling Guide
- Identify the location where you want to install the cabling guide.
- Position the cabling guide at an angle, ensuring that the angular deviation does not exceed 30 degrees.
- Insert one half of the cabling guide into the duct, aligning it with the opening.
- Gently push the cabling guide into the duct until it is securely in place.
- If necessary, repeat the process for the other half of the cabling guide.
Section 3: Drawing the Cable into the Duct
- Attach the cable to a suitable pulling device, such as a cable puller or fish tape.
- Insert the pulling device into the cabling guide.
- Slowly and steadily pull the cable through the cabling guide and into the duct.
- Continue pulling until the cable is fully drawn into the duct.
Specifications
-
Product Code: S83-0771
-
Short Description: Split cabling guide for angled ducts with
internal diameters of 89mm-92mm (96.5mm Duct) -
Angular Deviation: Maximum 30 degrees
-
Ref: 126401
FAQ
Q: What is the maximum angular deviation allowed for this cabling guide?
A: The maximum angular deviation allowed for this cabling guide is 30
degrees.
Product Code: S83-0771
Product Images
Short Description
Split cabling guide for angled ducts with internal diameters of 89mm-92mm
(96.5mm Duct).
Used to draw the cable into the duct at an angle, the angular deviation to be
no more than 30 degrees.
Description
Split cabling guide for angled ducts with internal diameters of 89mm-92mm
(96.5mm Duct).
Used to draw the cable into the duct at an angle, the angular deviation to be
no more than 30 degrees.
Ref: 126401
https://www.millsltd.com/default/guide-cabling-no-2.html
References
- Guide Cabling No 2 -Mills Ltd - London's Leading Supplier Of Structured Cabling & Specialist Tooling
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>