Les MILLS D2CRCKWS-B Wall Storage Instruction Manual
- June 12, 2024
- Les Mills
Table of Contents
Les MILLS D2CRCKWS-B Wall Storage
Introduction
IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING THIS PRODUCT PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
The Les Mills WALL STORAGE has been specifically designed for storing Les Mills equipment only.
It can store up to four Weight Plates or two SMARTBAR™. Alternatively, a combination of two Weight Plates and one SMARTBAR. Due to space restrictions, this number of Weight Plates and SMARTBAR should never be exceeded, even if the maximum weight detailed below is not met.
The maximum capacity per WALL STORAGE bracket is 40KG / 88LB. By way of example, the WALL STORAGE can store four Les Mills Weight Plates (weighing up to 10KG each), or two Les Mills Weight Plates (weighing up to 10KG each) and one SMARTBAR, or two SMARTBARs
SAFETY INFORMATION
WARNING: FAILURE TO ADHERE TO THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
CHOKING HAZARD: SMALL PARTS IN THE INSTALLATION KIT COULD PRESENT A CHOKING HAZARD.
NEVER EXCEED THE NUMBER OF WEIGHT PLATES AND SMARTBAR SPECIFIED EVEN IF THE MAXIMUM WEIGHT IS NOT MET.
- This WALL STORAGE is not a toy and should only be used by those aged 14 years or older.
- The owner of this WALL STORAGE is responsible for ensuring that all users of this product are adequately informed of all the safety information.
- Only use this WALL STORAGE as a storage facility for specified Les Mills equipment.
- This WALL STORAGE is only intended for personal domestic use. Do not use this product in any commercial or institutional setting.
- Do not place any additional load on the WALL STORAGE other than what it has been designed to accommodate.
- Choose a mounting location in a clearly accessible area with a flat, stable and level surface to lift the weights from, free from other obstructions such as slanted ceilings, and within easy reach of the user.
- Keep children away to prevent injury from climbing or hanging on the WALL STORAGE.
- Never leave children unsupervised with the WALL STORAGE.
- After assembling the WALL STORAGE, and before each use, carefully inspect to ensure there is no damage and the screws are tight.
CARE & MAINTENANCE
- After assembling the WALL STORAGE, and before each use, carefully inspect to ensure there is no damage and the screws are tight. Stop use of the WALL STORAGE immediately if there are any signs of damage.
- For cleaning, please wipe the WALL STORAGE with a clean, damp cloth with mild detergent. Please then dry with a clean, dry cloth.
- Keep the WALL STORAGE indoors and away from any moisture and dust.
- Do not attempt to repair the WALL STORAGE yourself.
- If you have any difficulties with the assembly or the use of this WALL STORAGE, or if you think that any parts are missing, please get in touch with your local Les Mills authorised equipment distributor.
- If you no longer want your WALL STORAGE, please dispose responsibly, in accordance with local household recycling guidelines.
PARTS INCLUDED
The Les Mills WALL STORAGE comprises of the following components:
-
2x WALL STORAGE brackets
-
4x Wall expansion anchors
-
4x 45mm long screws
You will also need the following tools:
-
Pencil
-
Stud Finder
-
Philips Screwdriver
-
Power Drill
-
Ø 5/32” (4mm) wood drill (for plasterboard/wood walls)
-
Ø 25/64” (10mm) concrete/brick drill (for concrete/brick walls.
INSTALLATION INSTRUCTIONS
Prior to assembly, remove all components from the packaging and check against the parts list on the previous page. If any parts are missing or you notice any sign of damage please return the WALL STORAGE to your local authorised equipment distributor. Please ensure that no equipment is placed on the WALL STORAGE bracket during assembly.
The WALL STORAGE bracket has been designed to be installed onto a plasterboard wall with a wooden stud, or a concrete/brick wall. Wall structures vary. Please consult a construction professional to confirm whether your wall structure is appropriate for installation of this WALL STORAGE bracket.
Ensure the bracket is installed with the prongs (where the weights will be
supported) angled upwards and the Les Mills logo at the bottom (as per the
image to the right).
The supplied wall plugs are suitable for standard concrete and brick walls. For other wall types, special wall plugs must be used. Please consult a construction professional for advice.
Prior to assembly, remove all components from the packaging and check against the parts list on the previous page.
PLASTERBOARD / DRYWALL INSTALLATION (for walls with existing studs)
STEP 1 Use a stud finder to locate and mark the location of the existing
studs in the wall.
STEP 2 Position the WALL STORAGE bracket ① in the desired location and
mark the center of the top and bottom holes over the stud.
Drill 5/32” (4mm) pilot holes into the stud at each marked location.
STEP 3 Using the supplied 45mm long screws ③, install the WALL STORAGE
bracket ① to the wall and tighten until the head of the screw sits flush with
the face of the bracket.
FOR CONCRETE / BRICK WALL INSTALLATION
STEP 1 Position the WALL STORAGE brackets ① in the desired location and
mark the center of the top and bottom holes.
Drill 25/64” (10mm) pilot holes at each marked location.
STEP 2 Install the supplied wall expansion anchors ② into the 25/64”
(10mm) holes until they sit flush with the wall.
STEP 3 Using the supplied 45mm long screws ③, install the WALL STORAGE
bracket ① to the wall and tighten until the head of the screw sits flush with
the face of the bracket.
Ensure the WALL STORAGE bracket is securely anchored, without any movement before use. We recommend testing the product by initially placing one weight onto the WALL STORAGE at a time.
WARRANTY INFORMATION
CONSUMER CUSTOMERS ONLY
As a consumer, you have statutory consumer rights and guarantees granted by law. This warranty is in addition to and does not replace or limit these rights. Your country or region has consumer protection groups or agencies that offer websites and other information which you may find helpful to understand your consumer rights.
At Les Mills Merchandise Limited (Les Mills) we stand behind our materials and manufacturing and offer customers who purchase the Les Mills WALL STORAGE for consumer use a two-year warranty for product defects that occur during the warranty period. Les Mills’ local distributor may, subject to your statutory consumer rights, replace a faulty WALL STORAGE bracket in accordance with the conditions set out below. This warranty applies in addition to, and is not intended to exclude, your statutory consumer rights under applicable law.
LIMITED TWO-YEAR WARRANTY TERMS
This limited warranty is valid only in countries where Les Mills has an authorised distributor. It covers manufacturing faults occurring during the warranty period when purchased from Les Mills or a distributor authorised by Les Mills. The limited warranty applies only to the original purchaser and does not cover second- hand equipment or re-sold equipment. The equipment must remain in the possession of the original buyer/owner. The limited warranty period lasts for two years and commences from the date on which the original buyer purchases the equipment. Warranty repairs will not extend the warranty period.
EXCLUSIONS
This limited warranty covers only failures due to manufacturing faults that occur during normal use and/or product defects that contravene your Mandatory Consumer Rights. This warranty does not extend to faults resulting from normal wear, misuse, abuse, corrosion, damage incurred during loading or relocating equipment, or where the WALL STORAGE bracket has been installed or used other than as recommended by Les Mills or modified without the consent of Les Mills.
Neither Les Mills nor its authorised local distributor will be liable for any defects due to reasons beyond their control.
Nothing in this Exclusions section shall exclude or limit any mandatory consumer protections that are available to you in your territory or any other liability which cannot be excluded by law. Further, there shall be no limits on the liability of Les Mills, agents acting on Les Mills’ behalf and/or its legal representatives in the event of fraud or their negligence resulting in personal injury or death.
THIS LIMITED WARRANTY IS THE EXCLUSIVE WARRANTY GIVEN BY LES MILLS AND SUPERSEDES ANY PRIOR, CONTRARY OR ADDITIONAL REPRESENTATIONS. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, EXCLUDING ANY STATUTORY WARRANTY TO WHICH YOU ARE ENTITLED UNDER YOUR MANDATORY CONSUMER RIGHTS, ARE DISCLAIMED EXCEPT TO THE EXTENT PROHIBITED BY LAW. IN SUCH EVENT, SUCH WARRANTY IS LIMITED TO THE DURATION OF THE WARRANTY PERIODS SET FORTH ABOVE. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER LEGAL RIGHTS, WHICH VARY FROM TERRITORY TO TERRITORY.
HOW TO MAKE A WARRANTY CLAIM
For enquiries, or to make a warranty claim, either contact your local Les Mills authorised equipment distributor or visit our website www.lesmills.com/merchandise/equipment/warranty. Warranty claims must be made within 30 days of the warranty incident and claims must be submitted with proof of purchase details. Claims must be made within the specified warranty period. Any replacement or repaired component will be warranted for the remainder of the original Limited Warranty period or 30 days, whichever is longer, or for any additional period that is required by applicable law.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>