MAXVIEW VuQube II Roof Mount and Portable Satellite TV Dome User Guide
- June 16, 2024
- MAXVIEW
Table of Contents
How to check a VuQube II is set to Astra 2.
VuQube II Roof Mount and Portable Satellite TV Dome
If your VuQube II is not locking on or is locking on but you are not getting a
signal on your TV, it could be because the correct satellite is not selected.
Please use the guide below to check you have the correct satellite selected.
When turned on the power injector will flash orange to show it is in start-up
mode.
To cycle through the
satellites, press and hold the button for 6 seconds (the light will flash 6
times), then release the button.
You can now press and release the button to change the colour. Each time you
press the button the light will change colour in this order, blue, green,
yellow then purple followed by the same colours again but with a white light
every other flash to indicate the alarm is set to on (if the colours do not
change you have left it too long before pressing the button and the power
injector has returned to search mode and you will need to start the process
again).
Once the colour for the satellite you want is flashing (green for Astra 2)
press and hold the button.
The light will be on solid for about 3 seconds and then start flashing again.
Once the light is flashing, release the button. The light will now flash with
the selected colour (green) showing the VuQube II is ready to search.
You can now press the button to start searching for your chosen satellite.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>