CUBETECH DG03 Wireless Speaker User Manual
- June 4, 2024
- CUBETECH
Table of Contents
User Manual
Wireless Speaker DG03
Key Description
Pause Playback Answer Call
+. Volume Up (Hold) Next
– Volume Down (Hold) Previous
Changer Model Bluetooth Mi model and FM model Changer Model (Hold)
Flashlight ON/OFF
**Wireless Pairing:
**
- Turn on the power switch, search for “DGO3” to select the connection; after the connection is successful, the wireless speaker will emita “di~” prompt.
- Press the “M” key to switch to the “FM mode”.
- Keep press the “M” key to control the flashlight OFF/ON
- When using the Bluetooth mode, the TF card needs to be pulled out.
FM radio mode: Before using the radio mode, always plug the charging
cable into the charging port. Press the “ ” key to switch to the “FM Mode”,
then press the “»” key to search for radio stations, and press”+””-“to switch
radio stations after the search is complete.
TF card playback: Insert the TF card into the card slot to play the music
stored in the card.
Precaution for use:
Please follow the instruction in the manual for correct use.
It is recommended to use this product in an environment of 0°-35°
The product is not a toy. Children under 14 need to use it under the
supervision of an adult.
Please do not use this product near a heat source. Please dispose of waste
electronic products properly. Do not use chemical solvents to wipe the surface
of the product.
Do not put the product close to your ears when playing music to prevent
hearing damage.
| Model: | DG03 |
|---|---|
| Connection distance: | 10M |
| Input: | 5V |
| Output power: | 5W |
| Speaker: | 40ΩW |
| Working voltage: | Dc 5V |
| Charging time: | 2-4 Hours |
| Battery capacity: | 1200mAh |
| Version: | 5.0 |
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to tadio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>