POLAR DM075-A Display Fridge Instruction Manual

DM075-A Display Fridge
Instruction Manual

DM075-A Display Fridge

Display fridge
Instruction manual
Model: DM075-A / DM076-A / GH426-A / GH427-A

Safety Instructions

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.

• Consult Local and National Standards to comply with the following:
  – Health and Safety at Work Legislation
  – Fire Precautions
  – IEE Wiring Regulations
  – Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.

• DO NOT use the appliance outside.

• DO NOT use this appliance to store medical supplies.

• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.

• DO NOT store products on top of the appliance.

• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.

• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.

• Always switch off and disconnect the power supply to the unit before cleaning.

• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.

• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.

• Children should be supervised to ensure that they do not play with the appliance.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the  use of the appliance by a person responsible for their safety.

• Polar recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity  and Functional Testing.

Caution: Risk of Fire

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
  Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.

• Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

• Warning: Do not damage the refrigerant circuit.

• Warning: Do not use electrical appliances inside the food storage compartments of the appliance.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents
The following is included:
POLAR Display fridge Shelves
Keys x 2 Instruction Manual
Door handle assembly
POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your POLAR dealer  immediately.

Installation

Note: Not for use in vans or trailers, food trucks or similar vehicles.
If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

1. Remove appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.

2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top.
   NEVER LOCATE NEXT TO A HEAT SOURCE.
   Note: Before using the appliance for the first time, clean the shelves and interior with soapy water then dry well.
   

3. Set the brakes on the castors to keep the appliance in position.

Mounting the door handle

1. Pull the door gasket aside to expose the 2 predrilled holes.
   Insert the screws.

2. Mount sleeve on the other end of screw. Tighten screws to fix the handle in place.

Reversing the door
Depending on the location of the appliance, it may be necessary to change the direction the door opens by changing the side of the door handle.
To reverse the door handle:

1. The door handle is on the left side originally.
2. Disassemble the front panel.
3. Cut the slot on the front panel and install the hinge inside.
4. Disassemble the right lower hinge and install it on the left lower side.
5. Reverse the door.
6. Disassemble the right upper hinge.
7. Install the left upper hinge.
8. At last, install the front panel. Now the door handle is on the right side.

Operation

Control Panel
The control panel is located below the doors on the front of the appliance.

To unlock / Lock the keyboard press and together for 3 seconds. Display will flash PON (unlocked) / POF (locked).

Turn On

1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
3. Turn the light switches On [I] or Off [O] as desired.

Set the Operating Temperature

1. Press the SET button. The display will flash.
2. Press the or buttons to display the required temperature.
3. Press the SET button to store the temperature.

Manual Defrost
Press and hold the defrost button “aux” for 2 seconds to begin a manual defrost. The defrost light illuminates.
Storing Food
To get the best results from your POLAR appliance, follow these instructions:

• Only store foodstuffs in the appliance when it has reached the correct operating temperature.
• Do not place uncovered items as below inside the appliance, as this can lead to a damaged and leaking evaporator, and thus void your warranty: hot food, hot liquids, acidic fluids, acidic products.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods of time.

Lock/Unlock the Doors

• A lock is fitted to the door to ensure foodstuffs are kept secure within your POLAR appliance.
• Use the keys provided to lock/unlock the door.

Cleaning, Care & Maintenance

• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.

Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also increase the amount of ice and internal/external condensation.
If external condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.
Replacing the Interior Lamp
WARNING: Allow the lamp to cool before replacing. The lamp remains hot immediately after use.

1. Turn Off and disconnect the appliance from the mains power supply.
2. Unscrew the plastic lamp cover.
3. Remove the lamp by twisting it from the lamp sockets.
4. Insert the new lamp and replace the cover.

Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
POLAR recommend that a POLAR agent or qualified technician clean the condenser.

Troubleshooting

A qualified technician must carry out repairs if required.

plugged in correctly and switched on
Plug or lead is damaged| Replace Plug or lead
Mains power supply fault| Check mains power supply
The appliance turns on, but the temperature is too high/low| Too much ice on the condenser| Defrost the appliance
Condenser blocked with dust| Clean the condenser
Doors are not shut properly| Check doors are shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the refrigerator to a more suitable location
Ambient temperature is too high| Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance| Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly levelled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to the drain is obstructed| Clear the floor of the appliance (if applicable)
The water container is damaged| Replace the water container
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change if necessary
The display lamp does not illuminate| Lamp needs replacing| Replace the lamp

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be subject to change without notice.

Model| Voltage| Power| Current| Temp. Range| Refrigerant| Dimensions H x W x D mm| Weight (kg)
---|---|---|---|---|---|---|---
DM075-A/GH426-A| 220-240V~

50Hz

| 146W| 1A| 2°C ~ 8°C| R600a| 1692 x 530 x 575| 124
DM076-A/GH427-A| 146W| 1.3A| 2°C ~ 8°C| R600a| 1982 x 620 x 570| 134
Model| Maximum load of each shelf| Gross Capacity (L)| Net usable capacity (L)
---|---|---|---
DM075-A/GH426-A| 12.5kg| 218| 180
DM076-A/GH427-A| 15kg| 368| 225

Note: For optimal product performance and efficiency, please ensure to mind the net usable capacity (load limit) when filling.

Electrical Wiring

The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

The appliances must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further  information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

1. G-Series Upright Display Fridge White – 218Ltr
2. G-Series Upright Display Fridge White – 350Ltr| 3. G-Series Upright Display Fridge Black – 218Ltr
4. G-Series Upright Display Fridge Black – 350Ltr| 1. DM075 (-E & -A)
2. DM076 (-E & -A)| 3. GH426 (-E & -A)
4. GH427 (-E & -A)
Application of Territory Legislation &   Council Directives(s)

| Machinery Directive 2006/42/EC Supply of Machinery (Safety) Regulations 2008
(BS) EN 60335-1:2012 +A11:2014 +A13:2017 +A1:2019 +A14:2019
(BS) EN 60335-2-89:2010 +A1:2016 +A2:2017
(BS) EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU – recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
(BS) EN 55014-1:2017
(BS) EN 55014-2:2015
(BS) EN 61000-3-2:2014
(BS) EN 61000-3-3:2013
Ecodesign energy-related products Directive
2009/125/EC; Regulation (EU) 2019/2024 – Ecodesign direct sales refrigerators
ISO 23953-2:2015
Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic
Equipment Regulations 2012 (S.I. 2012/3032)| Electrical Safety
IEC 60335-1:2010 +A1:2013 +A2:2016
IEC 60335-2-89:2010 +A1:2012 +A2:2015
EN 62233:2008
Electromagnetic Compatibility
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Producer Name| Polar

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Date
Signature
Full Name
Producer Address

http://www.polar-refrigerator.com/
DM075-A_DM076-A_GH426-A_GH427-A_A5_v7_2023/01/30

References

• Polar Refrigeration - Commercial Refrigeration

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>