SHANTOU 2BD4H-MD815-4A Transforming Robot RC Car Installation Guide
- June 16, 2024
- SHANTOU
Table of Contents
SHANTOU 2BD4H-MD815-4A Transforming Robot RC Car Installation Guide
Product Information
Specifications
- Product: Remote Control Car
- Compliance: FCC radiation exposure limits for an uncontrolled environment
- Minimum Distance: 20cm between the radiator and the body
Instructions for Transforming Robot RC car
- Function introduction of remote control
- Remote control/remote control car battery installation instructions
- Remote control operation instruction
Remote control car
Frequency specification complete.
Product Usage Instructions
Safety Precautions
Please follow these safety precautions while using the remote control car:
- Keep a minimum distance of 20cm between the radiator of the car and your body.
- Ensure that the car is operated in an uncontrolled environment.
- Avoid operating the car near sensitive electronic devices.
- Do not use the car if you have any medical devices or implants that may be affected by radio frequency emissions.
- Always supervise children while they are playing with the remote control car.
- Do not dismantle or modify the car as it may void the warranty and pose safety risks.
Installation
Follow these steps to install the remote control car:
- Place the car on a flat surface.
- Insert the batteries into both the car and the remote control, following the polarity markings.
- Ensure that the antennas on both the car and remote control are properly extended.
- Turn on the power switch on both the car and the remote control.
- The car is now ready to be operated.
Operating the Remote Control Car
Use the following instructions to operate the remote control car:
- Hold the remote control in your hand with a firm grip.
- Use the joystick or buttons on the remote control to control the car’s movements.
- Refer to the user manual for specific controls and features of the remote control car.
- Always operate the car within a safe distance and avoid obstacles.
- To stop the car, release the joystick or press the designated stop button on the remote control.
- After use, turn off the power switches on both the car and the remote control.
USB CHARGING INSTRUCTIONS
- The battery must be fully charged for the first time to ensure sufficient power. If the battery is not used for a long time, it will get over-discharged. Overcharging could also shorten the battery’s life.
- Users should check the wires, plugs, housings, and related components regularly. If they are damaged, please contact the seller for replacement.
- Use the correct adapter for charging:
- input: 100-240V* 50/60Hz 0.2A
- Output: 5.0V =- 500MA 0.5-1.5A. Do not use a quick charger.
- Charging instructions: Connect the battery to the intelligent USB charging cable. The intelligent USB charging cable can be connected to a power source with a USB socket to charge the battery.
Frequently Asked Questions (FAQ)
Q: Can I use the remote control car while holding it close to my body?
A: No, to comply with FCC radiation exposure limits, it is recommended to
maintain a minimum distance of 20cm between the radiator of the car and your
body.
Q: Are there any precautions I should take while using the remote control
car?
A: Yes, please refer to the safety precautions section in the user manual for
detailed instructions on safe usage.
Q: How far can I operate the remote control car from?
A: The remote control car can be operated within a reasonable range, typically
up to 30 meters. However, it may vary depending on obstacles and environmental
factors.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>