POLAR UA010-A Undercounter Fridge/Freezer Instruction Manual

June 16, 2024
Polar

**POLAR UA010-A Undercounter Fridge/Freezer Instruction Manual

**

Safety Instructions

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

  • Position on a flat, stable surface.
  • A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
    • In Queensland the service agent/qualified technician MUST hold a Gas Work Authorisation or License for hydrocarbon refrigerants if the appliance gas system is being opened or charged.
  • Consult Local and National Standards to comply with the following:
    • Health and Safety at Work Legislation
    • Fire Precautions
    • IEE Wiring Regulations
    • Building Regulations
  • DO NOT use jet/pressure washers to clean the appliance.
  • DO NOT use the appliance outside.
  • DO NOT use this appliance to store medical supplies.
  • DO NOT stand or support yourself on the base, drawers or  doors.
  • DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
  • Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.
  • Always switch off and disconnect the power supply to the unit before cleaning.
  • Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • POLAR recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing

Caution: Risk of Fire

  • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance

Warning : Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.

  • To comply with AS/NZS 60079.10.1:2009: Ensure there are not sources of ignition in any area where refrigerant could gather in the event of a leak.
  • Electrical equipment should not be placed under the vent or where refrigerant could gather in the event of a leak.
  • Warning : Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
  • Warning : Do not damage the refrigerant circuit.
  • Warning : Do not use electrical appliances inside the food storage compartments of the appliance

Product Description
UA010-A – Polar U-Series Undercounted fridge
UA011-A – Polar U-Series Undercounted freezer

Pack Contents

The following is included:

  • POLAR Fridge or Freezer
  • Instruction manual
  • Shelf guides
  • Shelves

POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your POLAR dealer immediately

Installation

Note : Not for use in vans or trailers, food trucks or similar vehicles.
Note : If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

  1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.

  2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top. NEVER LOCATE NEXT TO A HEAT SOURCE.
    Note : Before using the appliance for the first time, clean the shelves and interior with soapy water then dry well.

  3. Set the brakes on the castors to keep the appliance in position. Or level the appliance by adjusting the screw feet.

Fitting the Shelves

  1. Place one set of shelf guides on either side of the cabinet at the desired height.
  2. Slide the shelf into place.
  3. Slide the floor shelf in place.

Mounting the castors

Note : The appliance is supplied with feet by default. However, castors can be supplied as an option. Castors can be ordered using the code of AJ489.

To replace with the castors, follow below steps:

  1. Unscrew the feet.

  2. Mount the castors in place.

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:

  • Only store foodstuffs in the appliance when it has reached the correct operating temperature.
  • Do not place uncovered hot food or liquids (like acidic fluids) inside the appliance (as it can damage the evaporator).
  • Wrap or cover food where possible.
  • Do not obstruct the fans inside the appliance.
  • Avoid opening the door for prolonged periods of time.

Turn On

  1.  Close the door of the appliance.
  2. Ensure the power switch is set to [O] and turn on at the socket.
  3. Switch on the Power [I]. The current temperature within the appliance is displayed.

Control Panel

Control Panel

Set the Operating Temperature

  1. Press the SET button for 3 seconds. The display will flash.
  2. Press the or buttons to display the required temperature.
  3. Press the SET button to store the temperature.

Manual Defrost

  • Automatic defrost cycles are every 6 hours and last 25 minutes (factory defaults).
  • To manual defrost the appliance: Press and hold the defrost button “aux” for 2 seconds. The defrost light illuminates.
  • The defrost cycle will end automatically.

Cleaning, Care & Maintenance

Tip: Defrost appliance at least every 3 months, more often if required.

  • Switch off and disconnect from the power supply before cleaning.
  • Clean the appliance interior often as possible.
  • Do not use abrasive cleaning agents. These can leave harmful residues.
  • Clean the door seal with warm soapy water.
  • Always wipe dry after cleaning.
  • Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
  • Take care when cleaning the rear of the appliance. Sharp edges can cut.

Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also increase the amount of ice and internal/external condensation. If external condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.

Cleaning the Condenser Filter

  • The condenser is part of the refrigeration system. The condenser filter requires monthly cleaning.
  • Always disconnect power supply before carrying out Routine Maintenance.
  • Failure to clean the condenser filter will reduce the performance and life of your Polar unit and may invalidate your warranty.
  • These models have a removable filter which can be cleaned with a vacuum cleaner.
    Condenser Filter

Troubleshooting

A qualified technician must carry out repairs if required.

Fault Probable Cause Solution
Unit is not working The unit is not switched on Check the unit plugged in

correctly and switched on
Plug or lead is damaged| Replace plug or lead
Mains power supply fault| Check mains power supply
Unit turns on, but thetemperature is too high/low| Too much ice on the evaporator| Defrost the appliance
Condenser blocked with dust| Clean the Condenser
Door not shut properly| Check door is shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the refrigerator to a more suitable location
Ambient temperature is too high| Increase ventilation or move unit to a cooler position
Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored inside
Unit is leaking water| The appliance is not properly levelled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to the drain is obstructed| Clear the appliance floor (if applicable)
The drip tray is overflowing| Empty the drip tray (if applicable)
Unusual noise| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change if necessary

Technical Specifications

Note : Due to our continuing program of research and development, the specifications herein may be subject to change without notice

Model| Voltage| Power| Current| Temperature Range| Net usable capacity| Refrigerant| Dimensions H x W x D mm| Weight (kg)
---|---|---|---|---|---|---|---|---
UA010-A| 220-240V~,50Hz| 160W| 1.0A| -2°C to +8°C| 85L| R600a 60g| 829 x 680 x 700| 59kg
UA011-A| 220W| 2.0A| -25°C to -18°C| 85L| R290 55g| 829 x 680 x 700| 60kg

Note : For optimal product performance and efficiency, please ensure to mind the net usable capacity (load
limit) when filling

Electrical Wiring

The plug is to be connected to a suitable mains socket. This appliance is wired as follows:

  • Live wire (cultured brown) to terminal marked L
  • Neutral wire (cultured blue) to terminal marked N
  • Earth wire (cultured green/yellow) to terminal marked E

The appliances must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authorityesponsible for waste disposal in your area

POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to
change specifications without notice.

http://www.polar-refrigerator.com/
UA010-A UAD11-A AS_v1_2023/08/11

company Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals