TPI KT Series Line Voltage Thermostat Instruction Manual
- June 16, 2024
- TPI
Table of Contents
TPI KT Series Line Voltage Thermostat
ELECTRICAL RATING
Heating
22 AMP-125/277 VAC Res.
3/4 HP @ 125 VAC; 1 l/2 HP@ 250/277 VAC
82.8 LRA@ 125 VAC; 60 LRA@ 250 VAC
13.8 FLA@ 125 VAC; 10 FLA@250 VAC
Cooling
3/4 HP @ 125 VAC; 1 l/2 HP@ 250/277 VAC
82.8 LRA@ 125 VAC; 60 LRA@ 250 VAC
13.8 FLA@ 125 VAC; 10 FLA @250 VAC
UL LISTED/CSA CERTIFIED
Temperature range -10° to 100° F
Differential: Approximately 3° F Heating or Cooling
FEATURES
- A custom designed. Thermostat for automatic control of Line Voltage Systems.
- The bimetal sensing element provides accurate control for Heat or Cooling Systems. Snap-Action dust proof contact assures closer temperature control and longer life without radio and television interference.
- This Thermostat is easy to install and is an approved surface mounted control.
INSTALLATION INSTRUCTIONS
Locate 4 – 5 feet above the floor where the thermostat will not be affected directly by heat from the heater, outside drafts or the sun. A location that best samples average temperature of the controlled space is best.
CAUTION: On rough mounting surface, use top two mounting holes only. When
you mount this control on an uneven surface and pull all four mounting screws
down tight, you can twist the case enough to affect thermostat calibration and
operation.
All wiring should be done in accordance with applicable codes, ordinances and
regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>