MONSTER OPEN EAR 200 Wireless Earphone Sports Headset User Guide
- June 16, 2024
- Monster
Table of Contents
**MONSTER OPEN EAR 200 Wireless Earphone Sports Headset User Guide
**
Product Overview
Earphone x 2 (left & right)
Charging Case
USB-C Charging Cable
Quick Start Guide and Warranty Letter
- LED Indicator
- Multi Function Button（MFB）
- Charging contact point
- Speaker Areas
- Charging Indicator
- USB-C Charging Port
Power On/O
Open the cover of the charging case, take out the earphone, and it will tunutomatically. Put the earphone into the charging case, close the cover, and the earphone will automatically shut down and charge
Charging Case Charging
Use the USB-C charging cable delivered with the product to charge, and the
charging case indicator shows the charging status.
When the charging case is fully charged, the charging case indicator lights
up.
Pairing
Open the cover of the charging case, take out the earphone, and it will turn
on automatically. Later, you can hear “pairing” as a voice prompt. To connect
to a new device, please turn on the Bluetooth of your mobile phone and search
for “Monster Open Ear 200” to pairing the device. After successfully
connecting, you will hear “connected” voice prompt.
Volume Control
Volume down: Double tap the MFB on the left earphone during music streaming.
Volume up: Double tap the MFB on the right earphone during music streaming.
Call
Answer / End a call: Single tap the MFB.
Reject the call: Press and hold the MFB for about 2 seconds.
Music
Play/Pause music: Single tap the MFB
Previous song: Press and hold the MFB on the left earphone for about 2
seconds.
Next song: Press and hold the MFB on the right earphone for about 2 seconds.
Voice Control
With the earphones connected to the phone, press the MFB key three times to
activate or disable the voice assistant.
Reset
When the earphones is powered on and not connected to the Bluetooth device,
press the MFB button of the left and right earphones ve times at the same time
to restore factory Settings.
Indicator/Voice Prompt Guide
| Mode | Description | Voice Prompt |
|---|---|---|
| Power On | White LED light on | “Power On” |
| Power Off | White LED light off | “Power Off” |
| Pairing | The white LED light in the main ear blinks quickly, and the white LED | |
| lightin the secondary ear blinks every 6 seconds | “Pairing” | |
| Connected | White LED light off | “Connected” |
| Charging case | When charging, the indicator light on the charging case | |
| breathe, Keep itlit when it’s full | – |
Cautions
- After removing the earphones from the charging case, without pressing any buttons, the left and right earpieces will connect automatically. When no connections found, it will enter automatic pairing mode.
- Please place the earphones in the correct location (L/R) for normal charging.
- Replacement of battery (on your own) is not recommended.
- Do not expose battery (battery pack) to excessive heat such as direct sunlight or fire.
FCC Statement
es or mod ications not expressly ved by the party re for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help This device
complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation. The device has been evaluated to meet general
RF exposure requirement. The device can be used in portable exposure condition
without restriction.