AXTIVE SQUARE SQ-840 Portable Wireless Speaker User Guide

AXTIVE SQUARE SQ-840 Portable Wireless Speaker

Product Overview

1. Power on/off
2. Charging port
3. LED indicator

SPECIFICATIONS

• BT v5.2. Rechargeable 500 mAh Li-ion battery.
• Full charging time: around 2-3 hours.
• Battery playing time: up to 7 hours per charge (depending on volume level).
• Frequency range: 2402-2480GHz. Freq.
• Response: 60Hz-15KHz
• Charging input power: 5V DC/1A. RMS audio
• output: 3W. Impedance: 4Ω.

CARE, MAINTENANCE, SAFETY

Any modification of the product may have consequences for safety, warranty and proper functioning. Keep out of reach for children and animals. Product storage and working temperature: from -5 Celsius degrees to +40. Do not expose the product to direct sunlight, heat or naked flames as it may cause damage or explosion. Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately. Disconnect the product from the electrical outlet and other equipment if problems occur. Do not charge when the product is wet. Do not leave a battery on prolonged charge when not in use. Do not dismantle, open or shred batteries. Do not drop the product and avoid bumping. This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock etc. This device contains a lithium accumulator. Improper use can cause overheating and fire.

Pairing your AXTIVE SQUARE Wireless Speaker

1. Make sure the speaker is charged and turned OFF.
2. Press the ON/OFF switch (1) to turn the speaker on.
3. Activate BT on your phone or other device search for a new device and select AXTIVE SQUARE.
4. The speaker will remember your phone/device and automatically reconnect the next time you turn it on.
5. An unpaired speaker will automatically turn off after 10 minutes.

Charging the ACTIVE SQUARE speaker

1. Use a 5V/1A USB adapter for charging.
2. During charging the red light is on. When fully charged the red light is off.
3. Full charging time is around 2-3 hours with 1A.

Next time charging

1. When you hear a warning tone every 180 seconds, the battery status is low and needs charging.

Pairing and connecting
2 x ACTIVE SQUARE speakers with TWS

1. TWS only works when connecting two AXTIVE SQUAREs.
2. Turn on both speakers (BT mode). Make sure they are unconnected.
3. They will then wirelessly connect automatically by TWS.
4. One speaker emits a tone and the LED indicator light (3) will flash 2 times every 5 seconds. This is then the slave speaker.
5. Activate BT on your phone/device and connect with the master speaker.

To prevent possible hearing damage, do not listen at high volume levels for long periods.
Model No.: AXTIVE SQUARE
Designed in Denmark.
Produced in China.

This product complies with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity (DoC) may be consulted at:https://miiego.com/doc/ 
MIIEGO A/S Sintrupvej 2
8220 Brabrand
Denmark tel: +45 70 277 887
e-mail: support@miiego.com

References

• Startseite - Das neue Elektrogesetz (ElektroG, WEEE) 2024
• MIIEGO - Active Lifestyle Audio
• Declaration of Conformity – MIIEGO - Active Lifestyle Audio

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>