KODLin 3-1 Sleek Rear Indicators K68495 and K68496 for HD Touring Bikes Installation Guide
- June 4, 2024
- KODLin
Table of Contents
3-1 Sleek Rear Indicators K68495 and K68496 for HD Touring Bikes
Installation Guide
-
Remove both saddle bags and the seat.
-
Remove antenna mounting hardware from the left/right fender strut and the rubber grommet/plugs if used.
Note: You will need to relocate your antenna if you want to continue receiving AM/FM signals. -
Unplug the license plate and taillight harness from the right side of the rear facia light.
-
Remove the license plate/turn the signal light bar from the fender.
-
Unpackage your Sleek lights and remove the retaining plate from the back. Insert LED into housing with round opening then apply a small amount of medium strength thread locker on the stud. Place lock washer and nut over the stud and tighten snugly but do not over-tighten. This will hold the insert onto the housing.
-
Place housing into the opening for antenna feeding wires to the backside. Using thread locker on two small screws provided install retaining bracket onto the back side of LED housing. Check for proper alignment and tighten down snugly.
-
Repeat steps 5 and 6 for another side.
-
When wiring:
• Black = ground
• Yellow = running light
• Blue = turn signal
• Red = Stop
Note: If you are not comfortable with wiring, we recommend using one of the Kodlin Rear LED Install Kits for Touring Bikes. Using OEM connectors, it plugs into the harness under the seat and provides true 3-1 function, load balancing, and additional wires required for installation. -
Replace license plate mount, follow instructions for mounting provided with mount.
-
Test for proper operation.
-
Re-install seat and saddle bags.
For the latest install guides, videos, FAQ’s. and Tech-Tip’s scan QR code!
Revision Date:
2/3/2022
www.kodlinusa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>