wallbox Pulsar Plus Socket Instructions

: June 15, 2024
: wallbox

Table of Contents

References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**wallbox Pulsar Plus Socket Instructions

**

Safety and Maintenance Instructions

Installation, maintenance, & servicing of the charger must be performed only by qualified personnel per the applicable local regulations.
Unauthorized installation and modifications make the manufacturer warranty void.
Do not use if the enclosure or socket is broken, cracked, opened, or shows any indication of damage.
Please contact your distributor.
Do not touch the charger if the connector emits smoke or begins to melt.
If possible, stop charging.
Power off the charger before opening the cover or cleaning the unit. Do not use
cleaning solvents on any part of the charger. Use a clean, dry cloth to remove dust and dirt.
Do not open the cover in rain
Take appropriate precautions with electronic medical implants
Use the Wallbox charger under the operating parameters and within normal ambient conditions specified in the General and Electrical Specifications.
Ventilation not supported.
It is not recommended to install the charger in a position that has direct sunlight or under extreme weather conditions.

Simplified EU declaration of conformity

Hereby, Wall box declares that the equipment is in compliance with all regulations applicable and with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://support.wallbox.com/en/knowledge-base/ce-declaration/

Safety Recommendations

Follow all the safety and installation instructions carefully.
Failure to follow instructions may be a safety.
hazard and/or cause equipment malfunction.
Any resulting damage due to disregard or actions contrary to the instructions in this manual is excluded from the product warranty.

Connector Recommendations and Installation Instructions

Do not use if the charger connector is frayed, has broken insulation, or has any signs of damage or the electrical outlet is dirty, wet, or damaged.
Do not use the charger with a cable adapter or an extension cable
Under any circumstances, do not tighten the charging cable while it is connected.

Installation Instructions

Watch the installation video for your charger available at the Wallbox Academy web page: https://support.wallbox.com
Ensure that the mounting surface can adequately support the weight of the charger and withstand mechanical forces associated with usage.
The charger must be permanently connected to the
electrical Earth of the installation
Install the charger in a sufficiently ventilated area.
Avoid installing the charger near flammable, explosive, or combustible materials, chemicals or solvents, gas pipes or steam outlets, radiators or batteries, and areas prone to flooding, high humidity and running water.

Electrical Protection

The power supply line must be wired to an existing installation and be in accordance with local regulations.
The charger must be electrically protected by installing externally a Miniature Circuit Breaker (MCB) and a Residual Current Device (RCD).
MCB: C curve, 6kA rated short-circuit capacity. Rated current to be established at 1,25 times the minimum value between power supply and charger setting (i.e. 16A version with MCB 20A, 32A version with MCB 40A)
RCD: According to local regulations, Type A or Type B. Manual reset type only.
Local regulations may require an emergency switch to be installed externally.

Disposal Advice

In accordance to the Directive 2012/19/EC, at the end of its useful life, the product should not be disposed of as urban waste.
It should be taken to a collection center or to a distributor that provides disposal of special and differentiated waste.

Limited Warranty

Wallbox warrants this product against defects in materials and workmanship for a period of 3 years from the date of purchase.
During this period, at its discretion, Wallbox will either repair or replace any defective product at no charge to the owner.
Replacement products or repaired parts will be guaranteed for only the.
unexpired portion of the original warranty or six months whichever is greater.
Any defect resulting from any accident, misuse, improper maintenance, or normal wear and tear is not covered by the limited warranty.
Substitution or incorporation of any part by the client will be considered as incorrect usage.
Except to the extent permitted by applicable law, the terms of this limited warranty do not exclude, restrict, or modify, and are in addition to, the mandatory statutory rights applicable to the sale of the product to you.
If you believe your product is defective, contact Wallbox for instructions on where to send or bring it for repair.

Legal Notice

Any information in this manual may be changed without prior notice and does not represent any obligation on the part of the manufacturer.
Images in this manual are for illustration purposes only and might differ from the delivered product.

For more information on setting up your charger, visit the Wallbox Academy page: https://support.wallbox. com.

support.wallbox.com